TK111xxCS
LDO REGULATOR WITH ON/OFF CONTROL
TK111xxCS
1. DESCRIPTION
3. APPLICATIONS
TK111xxC is an integrated circuit of the silicon
monolithic bipolar structure, and the regulator of the
low saturation output type with very little quiescent
current (63mA).
Any Electronic Equipment
Battery Powered Systems
Mobile Communication
The PNP power transistor is Built-in to. The I/O voltage
difference when the current of Typ.200mA is supplied to
the system is 0.2V. The voltage source can be effectively
used.
4. PIN CONFIGURATION
Top View
Therefore, It is the best for the battery use set.
The on/off function is Built-in to IC. The current at
standing-by mode becomes slight (pA level).
1.5 to 10.0V is arranged to the output voltage in 0.1V step.
The output voltage is trimmed in high accuracy. The best
voltage for the set used will be able to be selected.
The over current sensor circuit and the reverse-bias over
current obstruction circuit are Built-in to.
Vcont
GND
Np
1
2
3
5
4
Vin
It is a design not broken because an ESD is also high. It is
possible to use (*O) at ease.
Vout
When mounting on PCB, the loss becomes about 500mW
though the package is very small.
TK111xxC uses the circuit with very high stability in DC
and AC.
The capacitor on the output side is steady in 0.1mF
(1.8V£Vout). The kind of this capacitor is not asked. It is
possible to use every type capacitor.
5. BLOCK DIAGRAM
Vin
Vout
However, a good characteristic is shown the more overall
larger this capacitor is.
The ripple rejection is 84dB at 400Hz and 80dB at 1kHz.
Over Heat
Over Current
Protection
&
Control
Circuit
2. FEATURES
Very good stability CL=0.1mF is steady enough. Any
type can be used.(1.8V£VOUT
)
Very low dropout Voltage. VDROP=120mV at 100mA
High Precision output voltage (±1.5% or ±50mV)
Good ripple rejection ratio(80dB at 1kHz)
Wide operating voltage range (1.8V to 14V)
Built-in Short circuit protection
Bandgap
Reference
Peak output current is 320mA.(0.3V down point)
Built-in thermal shutdown
Very low quiescent current (IQUT=63mA at IOUT=0mA)
Available very low noise application
Vcont
GND
Np
Built-in on/off control (0.1mA Max Standby current)
High On
Very small surface mount package
Built-in reverse bias over current protection
GC3-H008J
Page 2