FLEX TM ROAMING DECODER II
S5T8701
INTRODUCTION
32-LQFP-0707
This FLEXTM Roaming Decoder II date sheet describes the operation of the
S5T8701.
The S5T8701 simplifies implementation of a FLEXTM paging device by interfacing
with any of several off-the-shelf paging receivers and any of several off-the-shelf
host microcontroller/microprocessors. Its primary function is to process information
received and demodulated from a FLEX radio paging channel, select messages
addressed to the paging device and communicate the message information to the
host. The S5T8701 also operates the paging receiver in an efficient power
consumption mode and enables the host to operate in a low power mode when
monitoring a signal channel for message information.
FEATURES
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
FLEXTM paging protocol decoder
16 programmable user address words
16 fixed temporary addresses
16 operator messaging addresses
1600,3200,and 6400bps(bits per second) decoding
Any-phase or single-phase decoding
Uses standard Serial Peripheral Interface (SPI) in slave mode
Allow low current STOP mode operation of host processor
Highly programmable receiver control
Real time clock time base
FLEX fragmentation and group messaging support
Real time clock over-the-air update support
Compatible with synthesized receivers
SSID and NID Roaming support
Low Battery Indication(External detector)
28 used pins (32-pin package standard)
Backward compatible to the standard and roaming FLEX decoder ICs
Internal demodulator and data slicer
Improved battery savings via partial correlation and intermittent receiver clock
Full support for revision 1.9 of the FLEX protocol
32-pin LQFP package
Supply voltage: 1.8 to 3.6V
Operating Frequency: 76.8kHz or 160kHz
1