RT9536H
Operation
Multi-Loop Controller
The RT9536H is designed for single cell Li-Ion battery
charger in portable applications.
The Multi-Loop controller controls the operation during
the charging process. The controller will make sure the
battery is well charged in a suitable current, voltage, and
die temperature.
Base Circuit
The Base circuit provides the internal power for VDD, VREF
reference voltage and bias current.
Status Indicator
Power Switch with Switch Well Circuits
The CHGSB and PGB pin indicate the charger and power
condition. During the charging process, the CHGSB pin
is pulled low. When the charger is under charge done
condition or abnormal condition, the CHGSB will be high
impedance. The PGB pin indicates the input power status
at VIN pin. When the input power is normal, the PGB pin
is pulled low.
The main power switch between VINand BATT is designed
to control the charge current for battery. The switch well
is designed to avoid the reverse current from battery to
input power.
Sleep Mode
When the charger is only connected to battery with no
input power, the charger will enter sleep mode and the
leakage current from battery to the charger will be less
than 10μAfor low power consumption
Operation Mode
The RT9536H provides programmable output current mode
setting including USB100, USB500 and Factory mode.
The operation mode is programmable through the input
pulse number at EN/SET pin. Under the factory mode,
besides the EN/SET is also used to set regulation to be
4.25V or 4.4V. Output current is up to 2.3A.
Current Set Block
The charge current is adjustable from the ISET pin with
an external resistor between the ISET andGND. The End-
of-Charge current is also adjustable by an external resistor
connected from the IEOC pin to GND. If the charging
current is less than EOC current, the CHGSB pin will be
pulled high.
LDO
The RT9536H provides a LDO regulator to support the
peripheral circuits. The output voltage is regulated to 4.9V
and the maximum output current is 50mA.
Protection
The protection circuits include OVP, UVLO and OTP. When
the protection circuit is triggered, the main power switch
will be turned of to protect the charging system.
Copyright 2015 Richtek Technology Corporation. All rights reserved.
©
is a registered trademark of Richtek Technology Corporation.
DS9536H-01 August 2015
www.richtek.com
3