RA8803/8822
Version 2.1
Two Layers Character/Graphical LCD Controller
X’tal Input
XA
XB
I
In internal clock mode, this pin connects to external X’tal(32768Hz).
In external clock mode, this is an input of external clock.
X’tal Output
O
This pin connects to external X’tal(32768Hz).
4.4 Peripheral Interface
Pin Name
I/O
Description
Reset Signal
RST#
I
This is a reset signal used to reset RA8803/8822. Active low.
Touch Panel Input
X1
X2
Y1
Y2
I
I
I
I
This is connecting to the left pin of 4-wire touch panel.
Touch Panel Input
This is connecting to the right pin of 4-wire touch panel.
Touch Panel Input
This is connecting to the top pin of 4-wire touch panel.
Touch Panel Input
This is connecting to the bottom pin of 4-wire touch panel.
DAC Current Output
IOUT
O
DAC current source output used to contrast voltage control. This pin is tri-
state when DAC disbale.
Key Pad Input
KR[7..0]
KC[7.0]
I
These pins are keypad inputs.
Key Pad Output
O
O
I
These pins are keypad outputs.
Clock Output
CLK_OUT
SYS_NM
This is system clock output pin.
Test Pin
This is a test pin. Normally it has to connect high.
System Clock Select
This pin is used to select clock source.
Pull Low (0): X’tal/PLL Mode.
Pull High(1) : External Clock.
SYS_FQ
I
I
When SYS_FQ is Pull Low, then Internal oscillator and PLL are enable,
only one external 32Khz X’tal need.
When SYS_FQ is Pull High, then the system clock is from external pin
“XA”.
LCD Driver Data Bus Select
SYS_DW
This pin is used to select data bus of LCD driver is 8-Bit or 4-Bit:
Pull Low(0) : 4-Bit
RAiO TECHNOLOGY INC.
6/8
www.raio.com.tw