5秒后页面跳转
Q24T30015-NAB0G PDF预览

Q24T30015-NAB0G

更新时间: 2022-12-01 20:21:45
品牌 Logo 应用领域
BEL /
页数 文件大小 规格书
14页 251K
描述
DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, ROHS COMPLIANT, QUARTER BRICK, PACKAGE-8

Q24T30015-NAB0G 数据手册

 浏览型号Q24T30015-NAB0G的Datasheet PDF文件第3页浏览型号Q24T30015-NAB0G的Datasheet PDF文件第4页浏览型号Q24T30015-NAB0G的Datasheet PDF文件第5页浏览型号Q24T30015-NAB0G的Datasheet PDF文件第7页浏览型号Q24T30015-NAB0G的Datasheet PDF文件第8页浏览型号Q24T30015-NAB0G的Datasheet PDF文件第9页 
Q24T30015 DC-DC Converter Data Sheet  
18-36 VDC Input; 1.5 VDC @ 30A Output  
When using remote sense, the output voltage at the conver-  
ter can be increased by as much as 10% above the nominal  
rating in order to maintain the required voltage across the  
load. Therefore, the designer must, if necessary, decrease  
the maximum current (originally obtained from the derating  
curves) by the same percentage to ensure the converter’s  
actual output power remains at or below the maximum al-  
lowable output power.  
TM  
Family  
Q
Vin (+)  
ON/OFF  
Vin (-)  
Vout (+)  
SENSE (+)  
TRIM  
Converter  
(Top View)  
R T-INCR  
Rload  
Vin  
SENSE (-)  
Vout (-)  
Fig. 4: Configuration for increasing output voltage.  
Output Voltage Adjust /TRIM (Pin 6)  
The converter’s output voltage can be adjusted up 10% or  
down 20% relative to the rated output voltage by the addition  
of an externally connected resistor.  
RTDECR Required value of trim-down resistor [k]  
and Δ is as defined above.  
The TRIM pin should be left open if trimming is not being  
used. To minimize noise pickup, a 0.1 µF capacitor is con-  
nected internally between the TRIM and SENSE(-) pins.  
Note: The above equations for calculation of trim resistor  
values match those typically used in conventional industry-  
standard quarter bricks.  
To increase the output voltage, refer to Fig. 4. A trim resistor,  
R
T-INCR, should be connected between the TRIM (Pin 6) and  
TM  
SENSE(+) (Pin 7), with a value of:  
Family  
Q
Vin (+)  
ON/OFF  
Vin (-)  
Vout (+)  
SENSE (+)  
TRIM  
Converter  
(Top View)  
Rload  
5.11(100 Δ)VONOM 626  
Vin  
RT-DECR  
R
TINCR  
10.22 [k]  
SENSE (-)  
Vout (-)  
1.225Δ  
where,  
RTINCR Required value of trim-up resistor k]  
VONOM Nominal value of output voltage [V]  
Fig. 5: Configuration for decreasing output voltage.  
(VO-REQ VO-NOM)  
Trimming/sensing beyond 110% of the rated output voltage  
is not an acceptable design practice, as this condition could  
cause unwanted triggering of the output over-voltage protec-  
tion (OVP) circuit. The designer should ensure that the dif-  
ference between the voltages across the converter’s output  
pins and its sense pins does not exceed 0.15 V, or:  
Δ   
X 100 [%]  
VO -NOM  
VOREQ Desired (trimmed) output voltage [V].  
When trimming up, care must be taken not to exceed the  
converter‘s maximum allowable output power. See previous  
section for a complete discussion of this requirement.  
[VOUT() VOUT()][VSENSE() VSENSE()] 0.15  
[V]  
This equation is applicable for any condition of output sens-  
ing and/or output trim.  
To decrease the output voltage (Fig. 5), a trim resistor,  
RT-DECR, should be connected between the TRIM (Pin 6) and  
SENSE(-) (Pin 5), with a value of:  
511  
RTDECR  
10.22 [k]  
Δ
where,  
MCD10224 Rev. 1.0, 07-Sep-10  
Page 6 of 14  
www.power-one.com  

与Q24T30015-NAB0G相关器件

型号 品牌 描述 获取价格 数据表
Q24T30015-NAC0G BEL DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, ROHS COMPLIANT, QUARTER BRICK,

获取价格

Q24T30015-NACP BEL DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, QUARTER BRICK PACKAGE-8

获取价格

Q24T30015-NBA0 BEL DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, QUARTER BRICK, PACKAGE-8

获取价格

Q24T30015-NBAPG BEL DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, ROHS COMPLIANT, QUARTER BRICK

获取价格

Q24T30015-NBB0G BEL DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, ROHS COMPLIANT, QUARTER BRICK,

获取价格

Q24T30015-NBC0 BEL DC-DC Regulated Power Supply Module, 1 Output, 45W, Hybrid, QUARTER BRICK, PACKAGE-8

获取价格