5秒后页面跳转
PIC12F508-I-SN PDF预览

PIC12F508-I-SN

更新时间: 2024-01-07 23:14:24
品牌 Logo 应用领域
美国微芯 - MICROCHIP /
页数 文件大小 规格书
4页 277K
描述
PIC12F508/509 Rev. A Silicon/Data Sheet Errata

PIC12F508-I-SN 数据手册

 浏览型号PIC12F508-I-SN的Datasheet PDF文件第2页浏览型号PIC12F508-I-SN的Datasheet PDF文件第3页浏览型号PIC12F508-I-SN的Datasheet PDF文件第4页 
PIC12F508/509  
PIC12F508/509 Rev. A Silicon/Data Sheet Errata  
The PIC12F508/509 parts you have received conform  
functionally to the Device Data Sheet (DS41236C),  
except for the anomalies described below.  
2. Module: PIC12F509 debugging with ICD2  
(PIC16F505-ICD silicon) – Invalid  
FSR Power-Up Initialization  
All problems listed here will be addressed in future  
revisions of the PIC12F508/509 silicon. Where noted,  
problems apply to listed revision only.  
The FSR on the PIC16F505-ICD debugger silicon  
initializes to an invalid state. When using the ICD to  
debug software with the PIC16F505-ICD, bit 5 in the  
FSR register must be manually cleared to ‘0’ prior to  
saving data in user RAM space. The power-up default  
is ‘1’, which causes the device to Access Bank 1. The  
power-up defaults are correct on the non-ICD version  
of the PIC12F509 devices.  
1. Module: MPLAB® IDE, Revision 6.61 and  
Earlier  
MPLAB IDE 6.61 does not look for or set the  
Configuration Word in the hex file at the conven-  
tional logical location of 0xFFF.  
Work around:  
Work around:  
Add the following line of code to the top of your  
program;  
The CONFIG data must be assigned in two  
locations within the assembly code to ensure  
proper Configuration Word placement in the hex  
file. This is only required for MPLAB IDE version  
6.61 and earlier.  
BCF FSR,5 ;set bank pointers to bank 0  
This will have no effect on non-ICD devices, but will  
correct for the initialization errata on -ICD devices.  
Fixed Code  
3. Module: IPD, Power-Down Base current  
org  
0xYYYY  
data  
_CP_OFF & _WDT_ON & etc.  
On the PIC12F508/509 silicon, revisions earlier  
than A3, the power-down base current may remain  
higher than the specification for a short time when  
entering Sleep.  
__CONFIG _CP_OFF & _WDT_ON & etc.  
Re-locatable Code  
.config  
code 0xYYYY  
The following graph illustrates the device current  
upon entering Sleep:  
data  
data _CP_OFF & _WDT_ON &  
etc.  
FIGURE 1:  
__CONFIG data _CP_OFF & _WDT_ON &  
etc.  
IDD  
Configuration Word Address  
Device  
PIC12F508  
PIC12F509  
YYYY  
03FF  
07FF  
IPD  
Time  
Note: YYYY is the address of the Configuration  
Word for the part.  
Device enters  
Sleep  
Device current  
reaches IPD  
The length of time between the device entering  
Sleep mode and the device current reaching IPD  
increases as both temperature and voltage  
decrease.  
Work around  
This issue is fixed in Revisions A3 and later.  
© 2007 Microchip Technology Inc.  
DS80190G-page 1  

与PIC12F508-I-SN相关器件

型号 品牌 获取价格 描述 数据表
PIC12F508T MICROCHIP

获取价格

8/14-Pin, 8-Bit Flash Microcontrollers
PIC12F508TE/MC MICROCHIP

获取价格

8/14-Pin, 8-Bit Flash Microcontrollers
PIC12F508T-E/MC MICROCHIP

获取价格

8-BIT, FLASH, 4 MHz, RISC MICROCONTROLLER, PDSO8, 3 X 2 MM, 0.90 MM HEIGHT, LEAD FREE, PLA
PIC12F508TE/MG MICROCHIP

获取价格

8/14-Pin, 8-Bit Flash Microcontrollers
PIC12F508TE/MS MICROCHIP

获取价格

8/14-Pin, 8-Bit Flash Microcontrollers
PIC12F508T-E/MS MICROCHIP

获取价格

8-BIT, FLASH, 4 MHz, RISC MICROCONTROLLER, PDSO8, LEAD FREE, PLASTIC, MSOP-8
PIC12F508T-E/MSG MICROCHIP

获取价格

PIC12F508T-E/MSG
PIC12F508TE/P MICROCHIP

获取价格

8/14-Pin, 8-Bit Flash Microcontrollers
PIC12F508TE/SL MICROCHIP

获取价格

8/14-Pin, 8-Bit Flash Microcontrollers
PIC12F508T-E/SLG MICROCHIP

获取价格

PIC12F508T-E/SLG