Datasheet > PE1120BW-250.0M

PE1120BW-250.0M

更新时间： 2024-02-21 14:23:17

品牌	Logo	应用领域
PLETRONICS		/
页数	文件大小	规格书
1页	39K
描述
Oscillator, 10MHz Min, 250MHz Max, 250MHz Nom

阅读下载

中文翻译

获取价格

技术参数
数据手册

如果您发现信息不准确，欢迎纠错

PE1120BW-250.0M 技术参数

是否Rohs认证：	符合	生命周期：	Obsolete
包装说明：	DILCC6,.4	Reach Compliance Code：	compliant
风险等级：	5.84	安装特点：	SURFACE MOUNT
端子数量：	6	最大工作频率：	250 MHz
最小工作频率：	10 MHz	标称工作频率：	250 MHz
最高工作温度：	80 °C	最低工作温度：
封装主体材料：	CERAMIC	封装等效代码：	DILCC6,.4
电源：	2.5 V	认证状态：	Not Qualified
子类别：	Other Oscillators	最大压摆率：	90 mA
标称供电电压：	2.5 V	表面贴装：	YES
Base Number Matches：	1

PE1120BW-250.0M 数据手册

Pl tronics, Inc.

19013 36th Ave. W, Suite H Lynnwood, WA 98036 USA

Manufacturer of High Quality Frequency Control Products

PE1145B PECL Series

4 Pad Leadless Surface Mount Clock Oscillator

–

10.00 MHz 250.00 MHz

Differential PECL Output with Enable/ Disable Function

See PE1145T for higher frequencies

Standard Specifications

Overall Frequency Stability

± 50 PPM, ± 25 PPM, ± 20 PPM over Operating Temperature Range

Operating Temperature Range 0 to +80 C is standard, but can be extended to 40 to +85°C for certain frequencies

Supply Voltage (Vcc)

Supply Current (Icc)

Jitter

3.3 volts ± 10% standard, but 5.0 volts or 2.5 volts also available

60 to 70 mA typical, 90 mA maximum for 70 MHz. For < 70 MHz, consult factory

1 pS RMS maximum, from 12 kHz to 20 MHz from carrier for ³ 70 MHz. For < 70 MHz, consult factory

Output must be terminated into 50 ohms to (Vcc - 2.0 V). See Test Circuit 5 and Note 1.

Output enabled when E/D pin is open or at CMOS Logic “1”;

Output Load

Enable/Disable Option (E/D)

Output disabled when E/D pin is at CMOS Logic “0”.

Symmetry

Tr & Tf

Logic “1”

45/55% to 55/45% at 50% of Vcc level standard, tighter symmetry available

Output Waveform

PECL with Differential Output

(see Waveform 2)

1.0 nS max (20 to 80%) for 70 MHz. For < 70 MHz, consult factory

Vcc - 1.025 volts minimum

Vcc - 1.620 volts maximum

Logic “0”

Note 1:

In the typical PECL 100K logic output Voh is 2.35 volts and Vol is 1.60 volts at 3.3 Vcc. The center voltage of the PECL is therefore1.975 volts.

If a 50 ohm resistor is placed between the output and Vcc – 2 volts (1.3 volts), the current through the resistor is (1.975 – 1.3) / 50 = 13.5 mA.

The same load can be simulated by a resistor of 147 1% ohms to ground (1.975 / 0.0135 = 146.29 ohms). If additional load current is placed

on the output, its load current must be subtracted from the 13.5 mA to calculate a new load resistor. Using similar calculations, use 274 ± 1%

ohms to ground for 5.0V operation.

Part Numbering Guide

Portions of the part number that appear after the frequency may not be marked on part (C of C provided)

Packaging

Tray or

24mm tape,

16mm pitch

PE11 45 B Y - 70.0M - XXX (Internal Code or blank)

Model

Frequency in MHz

Special Specifications (choose all that apply)

E: Extended Operating Temperature Range (- 40 to +85 C)

Frequency Stability

F: 47.5 /52.5% Symmetry at 50% of Vcc

V: Supply Voltage of 3.3 volts ± 10%

W: Supply Voltage of 2.5 volts ± 5%

Y: Supply Voltage of 5.0 volts ± 10%

45 = ± 50 PPM

44 = ± 25 PPM

20 = ± 20 PPM

Consult factory for available frequencies and specs. Not all options available for all frequencies. A special part number may be assigned.

Frequency Stability is inclusive of frequency shifts due to calibration, temperature, supply voltage, shock, vibration and load

Mechanical: inches (mm)

not to scale

Due to part size and factory abilities, part marking may vary from lot to lot and may contain our part number or an internal code.

PE1145B Series

PE3X45B Series

Possible Pinout Options, Consult Factory for Alternate Pinouts

(Remove center pads

for PE3145B)

Q Out N.C. Vcc

Q Out

Vcc

Q Out QN Vcc

PLE

.05

(1.3)

Solder Pads

PE1145B

PE3145B

PE3345B

GND E/D QN Out

GND QN Out

GND E/D N.C.

For Best Performance,

Do NOT allow any traces other than ground

under oscillators (Even in buried layers)

.560 (14.23) MAX

.125 (3.17)

MAX

.200 (5.08)

Aug 2002

(425) 776 -1880, Fax: (425) 776-2760, ple-sales@pletronics.com, www.pletronics.com

Pl tronics, Inc.

中文翻译

下载PDF

与PE1120BW-250.0M相关器件

型号	品牌	获取价格	描述	数据表
PE1120BY-1.5M	PLETRONICS	获取价格	Oscillator
PE1120BY-10.0M	PLETRONICS	获取价格	Oscillator
PE1120BY-120.0M	PLETRONICS	获取价格	Oscillator
PE1120BY-170.00M	PLETRONICS	获取价格	Oscillator, 10MHz Min, 170MHz Max, 170MHz Nom
PE1120BY-170.0M	PLETRONICS	获取价格	Oscillator, 10MHz Min, 170MHz Max, 170MHz Nom
PE1120BYEF-FREQ	PLETRONICS	获取价格	PECL Output Clock Oscillator, 1.5MHz Min, 120MHz Max, LEADLESS PACKAGE-6
PE1120BYE-FREQ	PLETRONICS	获取价格	PECL Output Clock Oscillator, 1.5MHz Min, 107MHz Max, LEADLESS PACKAGE-6
PE1120BYF-FREQ	PLETRONICS	获取价格	PECL Output Clock Oscillator, 1.5MHz Min, 120MHz Max, LEADLESS PACKAGE-6
PE1120BY-FREQ	PLETRONICS	获取价格	PECL Output Clock Oscillator, 1.5MHz Min, 107MHz Max, LEADLESS PACKAGE-6
PE1120EW-FREQ-T1K	PLETRONICS	获取价格	PECL Output Clock Oscillator, 180MHz Min, 750MHz Max, ROHS COMPLIANT PACKAGE-6

产品中心

服务支持

精选活动

关于我们

帮助中心

PE1120BW-250.0M

PE1120BW-250.0M 技术参数

PE1120BW-250.0M 数据手册

与PE1120BW-250.0M相关器件

与PE1120BW-250.0M相关文章

您还可以找

产品中心

服务支持

精选活动

关于我们

帮助中心

PE1120BW-250.0M

PE1120BW-250.0M 技术参数

PE1120BW-250.0M 数据手册

与PE1120BW-250.0M相关器件

与PE1120BW-250.0M相关文章

您还可以找

您在本页遇到什么问题？