PCA9538
REMOTE 8-BIT I2C AND SMBus LOW-POWER I/O EXPANDER
WITH INTERRUPT OUTPUT, RESET, AND CONFIGURATION REGISTERS
www.ti.com
SCPS126D–SEPTEMBER 2006–REVISED MARCH 2007
Two hardware pins (A0 and A1) are used to program and vary the fixed I2C address and allow up to four
devices to share the same I2C bus or SMBus.
ORDERING INFORMATION
TA
PACKAGE(1)
ORDERABLE PART NUMBER
PCA9538RGTR
PCA9538RGVR
PCA9538DBQR
PCA9538DW
TOP-SIDE MARKING
PREVIEW
QFN – RGT
QFN – RGV
QSOP – DBQ
Reel of 3000
Reel of 2500
Reel of 2500
Tube of 40
PREVIEW
PD538
SOIC – DW
SSOP – DB
PCA9538
PD538
Reel of 2000
Reel of 2000
Tube of 80
PCA9538DWR
–40°C to 85°C
PCA9538DBR
PCA9538DB
Tube of 90
PCA9538PW
TSSOP – PW
TVSOP – DGV
PD538
PD538
Reel of 2000
Reel of 2000
PCA9538PWR
PCA9538DGVR
(1) For the most current package and ordering information, see the Package Option Addendum at the end of this document, or see the TI
website at www.ti.com.
TERMINAL FUNCTIONS
NO.
QSOP (DBQ),
NAME
DESCRIPTION
SSOP (DB),
TSSOP (PW), OR
TVSOP (DGV)
QFN (RGT) OR
QFN (RGV)
1
2
15
16
A0
A1
Address input. Connect directly to VCC or ground.
Address input. Connect directly to VCC or ground.
Active-low reset input. Connect to VCC through a pullup resistor if no active
connection is used.
3
1
RESET
4
5
2
3
P0
P1
P-port input/output. Push-pull design structure.
P-port input/output. Push-pull design structure.
P-port input/output. Push-pull design structure.
P-port input/output. Push-pull design structure.
Ground
6
4
P2
7
5
P3
8
6
GND
P4
9
7
P-port input/output. Push-pull design structure.
P-port input/output. Push-pull design structure.
P-port input/output. Push-pull design structure.
P-port input/output. Push-pull design structure.
Interrupt output. Connect to VCC through a pullup resistor.
Serial clock bus. Connect to VCC through a pullup resistor.
Serial data bus. Connect to VCC through a pullup resistor.
Supply voltage
10
11
12
13
14
15
16
8
P5
9
P6
10
11
12
13
14
P7
INT
SCL
SDA
VCC
2
Submit Documentation Feedback