DC Characteristics: (–30°C x TA x =60°C unless otherwise specified)
Parameter
Standby Current
Symbol
ISB
Test Conditions
VDD = 2.5V, Note 5
VDD = 2.5V, Note 6
VDD = 2.5V, VO = 0.5V
VDD = 2.5V, VO = 0.5V
VDD = 6V, VO = 6V
Min
Typ
1.0
100
2.0
4.0
0.001
–
Max Unit
–
5.0
200
–
µA
µA
mA
mA
µA
kΩ
pF
V
Operating Current
IOP
–
MUTE Sink Current
Pulse Sink Current
IML
0.5
IPL
1.0
–
MUTE Pulse Leakage Current
Key Contact Resistance
Keyboard Capacitance
“0” Logic Level
ILKG
RK1
CK1
VIL
–
1.0
1.0
3.0
0.2VDD
VDD
–
–
–
GND
0.8VDD
–
–
–
“1” Logic Level
VIN
–
V
Key Pull–Up Resistance
Key Pull–Down Resistance
KRU
KRD
VDD = 4V, Note 7
VDD = 4V, Note 7
100
5.0
kΩ
kΩ
–
–
Note 5. All output pins in no–load condition when clock is stopped in Off–Hook mode.
Note 6. All output pins in no–load condition during key input, in either On–Hook or Off–Hook Mode.
Note 7. Resistance when ROW and COL pins are scanned at 125Hz and at high or low level.
AC Characteristics:
Parameter
Oscillator Frequency
Key Debounce Time
Oscillator Start–Up Time
Pulse Rate
Symbol
fOSC
tDB
Test Conditions
Note 8
Min
–
Typ
480
32
–
Max Unit
–
–
kHz
ms
ms
pps
ms
ms
ms
ms
Note 9, Note 10
–
tOS
–
8.0
–
PR
Note 10
–
10
60
68
840
2
Break Time
tB
Pin9 = VDD, Note 10
Pin9 = GND, Note 10
Note 10
–
–
–
–
Inter–Digital Pause Time
tIDP
–
–
Mute Overlap Time
tMOL
Note 10
–
–
Note 8. Use elements with the following characteristics as the ceramic oscillator:
R < 20Ω, RA ≥ 70KΩ, CO ≤ 500pF.
Note 9. Key input is accepted if it is valid 32msec after the start of oscillation.
Note10. Changes in proportion to the frequency of the oscillator.
Functional Description:
Dialed Number Memory
During normal dialing, each digit is stored in the LND (Last Number Dialed) buffer, location 0. The
telephone number dialed can be left in this temporary LND buffer for later use or it can be copied into
any of the other nine permanent memory locations.
Telephone numbers to be automatically dialed by the NTE1731 may be entered into the LND buffer
while either On–Hook or Off–Hook.
Dialed Number Memory (Cont’d)
However, the NTE1731 must be in On–Hook mode for a number to be copied into a permanent
N
memory location. A number may be copied and stored by entering the key sequence