Spec No.: JELF243A_9137J-01
P3/9
8. AEC-Q200 Requirement
8.1 Performance [based on table 5 for magnetics (inductors/transformer) AEC-Q200 Rev. D issued June 1,
2010]
AEC-Q200
Murata specification/deviation
No.
3
Stress
Test method
High
1000 h at 125°C
Set for 24 h at room condition, then
measured.
Meet table A after testing.
Table A
temperature
exposure
Appearance
No damage
Within ±10%
Within ±10%
Inductance change (at 1 MHz)
DC resistance change
4
Temperature
cycling
1000 cycles
-40°C to +125°C
Meet table A after testing.
Set for 24 h at room condition, then
measured.
7
8
Biased humidity 1000 h at 85°C, 85% (RH). Unpowered. Meet table A after testing.
Operational life Apply rated current 85°C 1000 h
Set for 24 h at room condition, then
measured.
Meet table A after testing.
9
External visual Visual inspection
No abnormalities
No defects
10 Physical
dimension
Meet chapter 5, "Appearance and
Dimensions".
12 Resistance to
solvents
Per MIL-STD-202
Method 215
Not applicable
13 Mechanical
shock
Per MIL-STD-202
Method 213
Meet table A after testing.
100 g’s/6 ms/half sine
14 Vibration
5 g's for 20 min, 12 cycles each of 3
orientations
Meet table A after testing.
Test from 10 Hz to 2000 Hz
15 Resistance to
soldering heat
No-heating
Solder temperature
260°C±5°C
Pre-heating: 150°C to 180°C/90 s±30 s
Meet table A after testing.
Immersion time 10 s
17 ESD
Per AEC-Q200-002
Per J-STD-002
Meet chapter 3 ratings.
Appearance: no damage
18 Solderbility
Method b: not applicable
95% of the terminations is to be soldered (except exposed
wire).
19 Electrical
Measured: inductance
Per UL-94
No defects
characterization
20 Flammability
21 Board flex
Not applicable
Epoxy-PCB (1.6 mm)
Holding time: 5 s
Deflection 2 mm (min.)
60 s minimum holding time
Meet table A after testing.
22 Terminal
strength
Per AEC-Q200-006
A force of 17.7 N for 60 s
No defects
MURATA MFG CO., LTD