5秒后页面跳转
LM555CMMX PDF预览

LM555CMMX

更新时间: 2024-02-09 17:29:30
品牌 Logo 应用领域
美国国家半导体 - NSC 光电二极管
页数 文件大小 规格书
12页 392K
描述
Timer

LM555CMMX 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
Reach Compliance Code:unknownECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.13
Is Samacsys:N模拟集成电路 - 其他类型:PULSE; RECTANGULAR
JESD-30 代码:R-PDIP-T8JESD-609代码:e0
功能数量:1端子数量:8
最高工作温度:125 °C最低工作温度:-55 °C
封装主体材料:PLASTIC/EPOXY封装代码:DIP
封装等效代码:DIP8,.3封装形状:RECTANGULAR
封装形式:IN-LINE峰值回流温度(摄氏度):NOT SPECIFIED
电源:5/15 V认证状态:Not Qualified
子类别:Analog Waveform Generation Functions最大供电电流 (Isup):12 mA
最大供电电压 (Vsup):18 V最小供电电压 (Vsup):4.5 V
标称供电电压 (Vsup):15 V表面贴装:NO
技术:BIPOLAR温度等级:MILITARY
端子面层:Tin/Lead (Sn/Pb)端子形式:THROUGH-HOLE
端子节距:2.54 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIEDBase Number Matches:1

LM555CMMX 数据手册

 浏览型号LM555CMMX的Datasheet PDF文件第4页浏览型号LM555CMMX的Datasheet PDF文件第5页浏览型号LM555CMMX的Datasheet PDF文件第6页浏览型号LM555CMMX的Datasheet PDF文件第8页浏览型号LM555CMMX的Datasheet PDF文件第9页浏览型号LM555CMMX的Datasheet PDF文件第10页 
Applications Information  
MONOSTABLE OPERATION  
NOTE: In monostable operation, the trigger should be driven  
high before the end of timing cycle.  
In this mode of operation, the timer functions as a one-shot  
(Figure 1). The external capacitor is initially held discharged  
by a transistor inside the timer. Upon application of a nega-  
tive trigger pulse of less than 1/3 VCC to pin 2, the flip-flop is  
set which both releases the short circuit across the capacitor  
and drives the output high.  
DS007851-7  
FIGURE 3. Time Delay  
ASTABLE OPERATION  
If the circuit is connected as shown in Figure 4 (pins 2 and 6  
connected) it will trigger itself and free run as a multivibrator.  
The external capacitor charges through RA + RB and dis-  
charges through RB. Thus the duty cycle may be precisely  
set by the ratio of these two resistors.  
DS007851-5  
FIGURE 1. Monostable  
The voltage across the capacitor then increases exponen-  
tially for a period of t = 1.1 RA C, at the end of which time the  
voltage equals 2/3 VCC. The comparator then resets the  
flip-flop which in turn discharges the capacitor and drives the  
output to its low state. Figure 2 shows the waveforms gener-  
ated in this mode of operation. Since the charge and the  
threshold level of the comparator are both directly propor-  
tional to supply voltage, the timing internal is independent of  
supply.  
DS007851-8  
FIGURE 4. Astable  
DS007851-6  
In this mode of operation, the capacitor charges and dis-  
charges between 1/3 VCC and 2/3 VCC. As in the triggered  
mode, the charge and discharge times, and therefore the fre-  
quency are independent of the supply voltage.  
V
= 5V  
Top Trace: Input 5V/Div.  
CC  
TIME = 0.1 ms/DIV.  
= 9.1kΩ  
Middle Trace: Output 5V/Div.  
Bottom Trace: Capacitor Voltage 2V/Div.  
R
A
C = 0.01µF  
FIGURE 2. Monostable Waveforms  
During the timing cycle when the output is high, the further  
application of a trigger pulse will not effect the circuit so long  
as the trigger input is returned high at least 10µs before the  
end of the timing interval. However the circuit can be reset  
during this time by the application of a negative pulse to the  
reset terminal (pin 4). The output will then remain in the low  
state until a trigger pulse is again applied.  
When the reset function is not in use, it is recommended that  
it be connected to VCC to avoid any possibility of false trig-  
gering.  
Figure 3 is a nomograph for easy determination of R, C val-  
ues for various time delays.  
7
www.national.com  

与LM555CMMX相关器件

型号 品牌 描述 获取价格 数据表
LM555CMMX/NOPB TI Timing from Microseconds through Hours

获取价格

LM555CMX TI Timing from Microseconds through Hours

获取价格

LM555CMX NSC Timer

获取价格

LM555CMX ONSEMI 单计时器

获取价格

LM555CMX/NOPB TI Timing from Microseconds through Hours

获取价格

LM555CMX_12 FAIRCHILD Single Timer

获取价格