Datasheet > LM29150RS-1.5

LM29150RS-1.5

更新时间： 2024-02-17 05:57:13

阅读下载

获取价格

如果您发现信息不准确，欢迎纠错

LM29150RS-1.5 技术参数

生命周期：	Contact Manufacturer	包装说明：	TO-252, 3/2 PIN
Reach Compliance Code：	unknown	ECCN代码：	EAR99
HTS代码：	8542.39.00.01	风险等级：	5.67
最大回动电压 1：	0.6 V	最大输入电压：	26 V
最小输入电压：	2.5 V	JESD-30 代码：	R-PSSO-G2
功能数量：	1	端子数量：	2
工作温度TJ-Max：	125 °C	工作温度TJ-Min：	-40 °C
最大输出电流 1：	1.5 A	最大输出电压 1：	1.53 V
最小输出电压 1：	1.47 V	标称输出电压 1：	1.5 V
封装主体材料：	PLASTIC/EPOXY	封装代码：	TO-252
封装形状：	RECTANGULAR	封装形式：	SMALL OUTLINE
调节器类型：	FIXED POSITIVE SINGLE OUTPUT LDO REGULATOR	表面贴装：	YES
端子形式：	GULL WING	端子位置：	SINGLE
Base Number Matches：	1

1.5A Very L.D.O Voltage Regulator

LM29150/1/2/3

Minimum Load Current

The LM29150 regulators are specified between finite loads. If the output is too small, leakage

currents is too small, leakage currents dominate and the output voltage rises. The 5mA minimum

load current swamps any expected leakage current across the operating temperature range.

Adjustable Regulator Design

Figure 4.

Adjustable Regulator with Resistors

VOUT=1.240V x [ 1+(R1/R2)]

The adjustable regulator versions, LM29152 and LM29153, allow programming the output voltage

anywhere between 1.25V and the 26V maximum operating rating of the family.

Two resistors are used. Resistors can be quite large, up to 1MΩ, because of the very high input

impedance and low bias current of the sense comparator: The resistor values are calculated by:

Where is VO the desired output voltage. Figure 4 shows component definition. Applications with

widely varying load currents may scale the resistors to draw the minimum load current required for

proper operation.

Error Flag

LM29151 and LM29153 versions feature and Error Flag, which looks at the output voltage and

signals and error condition when this voltage and signals an error condition when this voltage

drops 5% below its expected value. The error flag is an open-collector output that pulls low

under fault conditions. It may sink 10mA. Low output voltage signifies a number of possible

problems, including an over-current fault (the device is in current limit) and low input voltage.

The flag output is inoperative during over temperature shutdwon conditions.

Enable input

LM29151 and LM29152 versions feature and enable (EN) input that allows ON/OFF control of the

device. Special design allows "zero" current drain when the device is disabled-only microamperes

of leakage current flows. The EN input has TTL/CMOS compatible thresholds for simple interfacing

with logic, or may be directly tied to ≤ 30V. Enabling the regulator requires approximately 20uA of

current.

Mar. 2006-Rev06

HTC

1...4 5 67

下载PDF