5秒后页面跳转
HSSR-8060#500 PDF预览

HSSR-8060#500

更新时间: 2024-01-29 10:35:04
品牌 Logo 应用领域
安捷伦 - AGILENT /
页数 文件大小 规格书
12页 253K
描述
Solid State Relay, 1-Channel, 2500V Isolation

HSSR-8060#500 技术参数

是否Rohs认证: 不符合生命周期:Obsolete
Reach Compliance Code:unknown风险等级:5.92
控制电流:0.02 A控制电压:1.85 V
输入类型:DC最大绝缘电压:2500 V
JESD-609代码:e0元件数量:1
最高工作温度:85 °C最低工作温度:-40 °C
输出电路类型:MOSFET总高度:4.2 mm
总长度:9.7 mm子类别:Solid State Relays
端子面层:Tin/Lead (Sn/Pb)Base Number Matches:1

HSSR-8060#500 数据手册

 浏览型号HSSR-8060#500的Datasheet PDF文件第2页浏览型号HSSR-8060#500的Datasheet PDF文件第3页浏览型号HSSR-8060#500的Datasheet PDF文件第4页浏览型号HSSR-8060#500的Datasheet PDF文件第5页浏览型号HSSR-8060#500的Datasheet PDF文件第6页浏览型号HSSR-8060#500的Datasheet PDF文件第7页 
60 V/0.7 Ohm,  
General Purpose, 1 Form A,  
Solid State Relay  
Technical Data  
HSSR-8060  
Features  
• Compact Solid-State  
Bidirectional Switch  
• Normally-Off Single-Pole  
Relay Function (1 Form A)  
• 60 V Output Withstand  
Voltage in Both Polarities at  
25°C  
• 0.75/1.5 Amp Current  
Ratings (See Schematic for  
Connections A & B)  
• Low Input Current; CMOS  
Compatibility  
• Very Low On-resistance:  
0.4 Typical at 25°C  
• ac/dc Signal and Power  
Switching  
• Input-to-Output Momentary  
Withstand Insulation  
Voltage: 2500 Vac, 1 Minute  
• 16-kV ESD Immunity: MIL-  
STD-883, Method 3015  
• IEEE Surge Withstand  
Capability (IEEE STD  
472-1974)  
• Telecommunication  
Switching Equipment  
• Reed Relay Replacement  
• 28 Vdc, 24 Vac, 48 Vdc Load  
Driver  
• Industrial Relay Coil Driver  
switch either ac or dc loads.  
Connection B, with the polarity  
and pin configuration as indicated  
in the schematic, allows the relay  
to switch dc loads only. The  
advantage of Connection B is that  
the on-resistance is significantly  
reduced, and the output current  
capability increases by a factor of  
two.  
Description  
The HSSR-8060 consists of a  
high-voltage circuit, optically  
coupled with a light emitting  
diode (LED). This device is a  
solid-state replacement for single-  
pole, normally-open (1 Form A)  
electromechanical relays used for  
general purpose switching of  
signals and low-power loads. The  
relay turns on (contact closes)  
with a minimum input current, IF,  
of 5 mA through the input LED.  
The relay turns off (contact  
opens) with an input voltage, VF,  
of 0.8 V or less. The detector  
contains a high speed photosensi-  
tive FET driver circuit and two  
high voltage MOSFETs.  
The electrical and switching char-  
acteristics of the HSSR-8060 are  
specified from -40°C to +85°C.  
Functional Diagram  
• CSA Approved  
• UL 508 Approved  
This relay’s logic level input con-  
trol and very low typical output  
on-resistance of 0.4 makes it  
suitable for both ac and dc loads.  
Connection A, as shown in the  
schematic, allows the relay to  
TRUTH TABLE  
(POSITIVE LOGIC)  
Applications  
• Programmable Logic  
Controllers  
LED  
ON  
OUTPUT  
L
OFF  
H
CAUTION: It is advised that normal static precautions be taken in handling and assembly of this component to  
prevent damage and/or degradation which may be induced by ESD.  

与HSSR-8060#500相关器件

型号 品牌 获取价格 描述 数据表
HSSR8200 ETC

获取价格

HSSR-8200 AVAGO

获取价格

TRANSISTOR OUTPUT SOLID STATE RELAY, 2500V ISOLATION-MAX
HSSR-8200 AGILENT

获取价格

200-V/160 Ohm, 1 Form A, Small-Signal Solid State Relay
HSSR-8200 HP

获取价格

60 V/0.7 Ohm, General Purpose, 1 Form A, Solid State Relay
HSSR8200#300 ETC

获取价格

HSSR-8200#300 AGILENT

获取价格

Solid State Relay
HSSR-8200#500 AGILENT

获取价格

Solid State Relay
HSSR-8200300 AVAGO

获取价格

Transistor Output SSR, 1-Channel, 2500V Isolation
HSSR-8200500 AVAGO

获取价格

Transistor Output SSR, 1-Channel, 2500V Isolation
HSSR8400 ETC

获取价格