Transmitter Electrical Characteristics
(Over recommended operating conditions: Tc= 0ºC to +80ºC, V =3.3V + 5%)
cc
Parameter
Symbol
Minimum Typical
Maximum Unit
Reference
W
Differential Input Impedance
Zin
80
100
120
100
7.5
18
1, Figure 9
FAULT* Assert time
TOFF
TOFF
TON
TON
TOFF
TOFF
TON
µs
µs
ms
ms
µs
µs
ms
ms
mA
mA
V
Figure 13
RESET* Assert time
Figure 14
RESET* De-assert time
Figure 14
Transmit Enable (TX_EN) Assert time
Transmit Enable (TX_EN) De-assert time
Transmit Disable (TX_DIS) Assert time
Transmit Disable (TX_DIS) De-assert time
Power-On Initiation Time
18
Figure 15
7.5
7.5
18
Figure 15
Figure 15
Figure 15
21
Figure 17
Control I/Os
TX _DIS, TX_EN,
TX_FAULT*,
Input Current High
Input Current Low
Output Voltage Low
Output Voltage High
| IIH
|
0.5
0.5
0.4
VCC
2.0 V < VIH < VCC
VEE < VIH < 0.8 V
IOL = 4.0 mA
IOH = -0.5 mA
| IIL |
VOL
VEE
2.4
TX_RESET*
VOH
V
Transmitter Optical Characteristics
(Over recommended operating conditions: Tc= 0ºC to +80ºC, V =3.3V + 5%)
cc
Parameter
Symbol
Minimum Typical
Maximum Unit
Reference
Optical Modulation Amplitude
-7.22
dBm
OMA
lC
Center Wavelength
Spectral Width - rms
Rise, Fall Time
830
850
860
0.85
100
100
-119.5
60
nm
s
nm rms
ps
tr, tf
60
50
2
3
Inter-channel Skew
Relative Intensity Noise OMA
ps
dB/Hz
ps
RIN12OMA
DJ
Jitter Contribution
Deterministic
Total
4
5
6
TJ
120
-2.0
ps
Output Optical Power, 50/125 um, Fiber NA =0.2
POUT
dBm Avg.
Notes:
1. Differential impedance is measured between DIN+ and DIN- over the range 4 MHz to 2 GHz.
2. These are unfiltered 20% - 80% values measured with a 550 MBd 101010 pattern.
3. Inter-channel Skew is defined for the condition of equal amplitude, zero ps skew input signals.
4. Deterministic Jitter (DJ) is defined as the combination of Duty Cycle Distortion (Pulse-Width Distortion) and Data Dependent Jitter. Deterministic
7
Jitter is measured at the 50% signal threshold level using a 3.125 GBd Pseudo Random Bit Sequence of length 2 -1 (PBRS7), or equivalent, test
pattern with zero skew between the differential data input signals.
5. Total Jitter (TJ) includes Deterministic Jitter and Random Jitter (RJ). Total Jitter is specified at a BER of 10 for the same 3.125 GBd test pattern
-12
as for DJ and is measured with all channels operating.
6. The specified optical output power, measured at the output of a 2meter test cable, will be compliant with IEC 60825-1 Amendment 2, Class 1M
Accessible Emission Limits, AEL Regulatory Compliance section.
7