Transmitter Electrical Characteristics
(Over recommended operating conditions: Tc= 0ºC to +80ºC, Vcc=3.3V + 5%)
Parameter
Symbol
Zin
Minimum Typical
Maximum Unit
Reference
W
Differential Input Impedance
FAULT* Assert time
80
100
120
100
7.5
18
1, Figure 9
Figure 13
TOFF
TOFF
TON
µs
µs
ms
ms
µs
µs
ms
ms
mA
mA
V
RESET* Assert time
Figure 14
RESET* De-assert time
Figure 14
Transmit Enable (TX_EN) Assert time
Transmit Enable (TX_EN) De-assert time
Transmit Disable (TX_DIS) Assert time
Transmit Disable (TX_DIS) De-assert time
Power-On Initiation Time
TON
18
Figure 15
TOFF
TOFF
TON
7.5
7.5
18
Figure 15
Figure 15
Figure 15
21
Figure 17
Control I/Os
TX _DIS, TX_EN,TX_
FAULT*,TX_RESET*
Input Current High
Input Current Low
Output Voltage Low
Output Voltage High
| IIH
| IIL
|
0.5
0.5
0.4
VCC
2.0 V < ꢀVIH < VCC
VEE < VIH < 0.8 V
IOL = 4.0 mA
IOH = -0.5 mA
|
VOL
VOH
VEE
2.4
V
Transmitter Optical Characteristics
(Over recommended operating conditions: Tc= 0ºC to +80ºC, Vcc=3.3V + 5%)
Parameter
Symbol
OMA
lC
Minimum Typical
Maximum Unit
Reference
Optical Modulation Amplitude
Center Wavelength
Spectral Width - rms
Rise, Fall Time
-7.22
dBm
830
850
860
0.85
100
100
-119.5
60
nm
s
nm rms
ps
tr, tf
60
50
2
3
Inter-channel Skew
Relative Intensity Noise OMA
ps
RIN12OMA
dB/Hz
ps
Jitter Contribution
Deterministic
Total
DJ
TJ
4
5
6
120
-2.0
ps
Output Optical Power, 50/125 um, Fiber NA =0.2 POUT
dBm Avg.
Notes:
1. Differential impedance is measured between Din+ and Din- over the range 4 MHz to 2 GHz.
2. These are unfiltered 20% - 80% values measured with a 550 MBd 101010 pattern.
3. Inter-channel Skew is defined for the condition of equal amplitude, zero ps skew input signals.
4. Deterministic Jitter (DJ) is defined as the combination of Duty Cycle Distortion (Pulse-Width Distortion) and Data Dependent Jitter. Determin-
7
istic Jitter is measured at the 50% signal threshold level using a 3.125 GBd Pseudo Random Bit Sequence of length 2 -1 (PBRS7), or equiva-
lent, test pattern with zero skew between the differential data input signals.
5. Total Jitter (TJ) includes Deterministic Jitter and Random Jitter (RJ). Total Jitter is specified at a BER of 10 for the same 3.125 GBd test pat-
-12
tern as for DJ and is measured with all channels operating.
6. The specified optical output power, measured at the output of a 2meter test cable, will be compliant with IEC 60825-1 Amendment 2, Class
1M Accessible Emission Limits, AEL Regulatory Compliance section.
7