GR8210
Universal and Dimmable LED Driver
Features
ꢀ
General Description
Input voltage range from 5V to 450V
The GR8210 is a high brightness LED driver with
the cascode topology that patented by Grenergy. A
high voltage power NMOSFET, BVDSS is 600V, as
the high side device and the power NMOSFET
inside the GR8210 as the low side device in this
cascode topology. A Zener voltage, was generated
by ST pin of the GR8210, turn on the high side
device all the time by connected to the gate terminal
of the high side device. The source terminal and the
drain terminal of the high side device are connected
to the DRN pin of the GR8210 and the input voltage
rail respectively to absorb the very large voltage
potential. The current peak value was decided by
the sensing resistor in the CS pin, the low side
device was turned off by the current peak detection
then delay a fixed off time that set by the resistor in
the RT pin of GR8210.
ꢀ
Cascode topology for lower switching loss and
surge voltage
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Constant off time control
Line compensation of output current
Enable pin
Switch/PWM/Linear dimming function
Leading-edge blanking
Frequency modulation in short circuit
protection and low output voltage condition
Over-temperature protection
Over-current protection
ꢀ
ꢀ
ꢀ
SOP-8 package, with few external components
needed
Application
ꢀ
ꢀ
ꢀ
ꢀ
DC/DC or AC/DC LED driver application
LED T-bar lighting
There are PWM and liner dimming in GR8210 to
adjust the LED brightness. In the abnormal
operation, the inner OTP function could protect the
IC damage.
Cabin light in car
Both non-isolation and isolation lighting in high
input voltage
* Refer to Feature List on page 2 for the switching dimming
function
Ordering and Marking Information
SOP-8
Grenergy OPTO Inc. reserves the right to make changes to improve reliability or manufacture ability without notice, and
advise customers to obtain the latest version of relevant information to verify before placing orders.
2010.04 Ver. 1.01 Copyright Grenergy OPTO, Inc. www.grenergy-ic.com
1