G70D
G70D
Nameplate of Terminal Block
Electrical Check Terminals
As shown in Figure 1, the nameplate of the terminal block is
located on the bottom surface of the relay block.
The terminal block of the G70D-VSOC16 in operation is located
under the relay block. Therefore, unlike the terminal blocks of
other models, electrical checks on the terminals are not possible
with multimeter probes. The relay block of the G70D-VSOC16,
however, incorporates electrical check terminals, each of which is
connected to the corresponding terminal of the terminal block. All
the pairs of these terminals share single terminal numbers
respectively.
To fill in the nameplate, remove the nameplate from the relay
block. Then return it to the original location when finished.
To read the nameplate after the Output Block is mounted to a
panel, for example, pull out the nameplate from the bottom
surface of the relay block as shown in Figure 2.
To check these terminals, apply multimeter probes to these
terminals.
Do not touch these energized terminals with a thin metal object
or similar objects. Doing so may result in an electric shock.
Relay block
Nameplate
Figure 1
Multimeter probes
Nameplate
Electrical check terminals
Figure 2
Mounting the Expansion Terminal Block
Insert the hooks of the Expansion Terminal Block into the
mounting holes on the terminal block and slide the Expansion
Terminal Block so that it will not separate from the terminal block.
Tighten the mounting screw of the Expansion Terminal Block
securely.
Terminal block
Mounting screw
Expansion Terminal Block
NOTE: DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters to inches divide by 25.4.
9
OMRON ELECTRONICS, INC.
OMRON CANADA, INC.
One East Commerce Drive
885 Milner Avenue
Schaumburg, IL 60173
Scarborough, Ontario M1B 5V
1-800-55-OMRON
416-286-6465
Cat. No. J099-E3-1
04/00
Specifications subject to change without notice.
Printed in U.S.A.