FTLF1324P2xTy Industrial Temp. SFP Product Specification – February 2007
F i n i s a r
I.
Pin Descriptions
Pin
Symbol
Name/Description
Ref.
1
2
3
4
5
6
7
VEET
TFAULT
TDIS
Transmitter Ground (Common with Receiver Ground)
Transmitter Fault. Not supported.
Transmitter Disable. Laser output disabled on high or open.
1
2
3
3
3
4
MOD_DEF(2) Module Definition 2. Data line for Serial ID.
MOD_DEF(1) Module Definition 1. Clock line for Serial ID.
MOD_DEF(0) Module Definition 0. Grounded within the module.
Rate Select
Open or Low =
1.063 Gb/s or 2.125 Gb/s Fibre Channel, 1.25 Gb/s
Gigabit Ethernet (Low Bandwidth)
High =
2.125 or 4.25 Gb/s Fibre Channel (High Bandwidth)
8
9
LOS
VEER
VEER
VEER
RD-
RD+
VEER
VCCR
VCCT
VEET
TD+
TD-
Loss of Signal indication. Logic 0 indicates normal operation.
Receiver Ground (Common with Transmitter Ground)
Receiver Ground (Common with Transmitter Ground)
Receiver Ground (Common with Transmitter Ground)
Receiver Inverted DATA out. AC Coupled
Receiver Non-inverted DATA out. AC Coupled
Receiver Ground (Common with Transmitter Ground)
Receiver Power Supply
5
1
1
1
10
11
12
13
14
15
16
17
18
19
20
1
1
1
Transmitter Power Supply
Transmitter Ground (Common with Receiver Ground)
Transmitter Non-Inverted DATA in. AC Coupled.
Transmitter Inverted DATA in. AC Coupled.
Transmitter Ground (Common with Receiver Ground)
VEET
Notes:
1. Circuit ground is internally isolated from chassis ground.
2. Laser output disabled on TDIS >2.0V or open, enabled on TDIS <0.8V.
3. Should be pulled up with 4.7k - 10 kohms on host board to a voltage between 2.0V and 3.6V.
MOD_DEF(0) pulls line low to indicate module is plugged in.
4. For Rate Selectable version only: In accordance with SFF Committee SFF-8079 Draft, Rev.1.6,
Table 3. Note that rate select can also be set through 2-wire bus in accordance with SFF-84726 at Bit
3, Byte 110, Address A2h (note: writing ‘1’ selects full bandwidth operation). Rate select is the logic
OR of the input state of Rate Select Pin and 2-wire bus. Non Rate Selectable version can operate at 1x,
2x, 4x Fibre Channel independent of rate select pin setting.
5. LOS is open collector output. Should be pulled up with 4.7k – 10 kohms on host board to a voltage
between 2.0V and 3.6V. Logic 0 indicates normal operation; logic 1 indicates loss of signal.
VeeT
TD-
20
19
18
17
16
15
14
13
12
11
VeeT
1
2
TXFault
TD+
3
TX Disable
MOD-DEF(2)
MOD-DEF(1)
MOD-DEF(0)
Rate Select
LOS
VeeT
VccT
VccR
VeeR
RD+
RD-
4
5
Towards
Bezel
Towards
ASIC
6
7
8
9
VeeR
VeeR
VeeR
10
Pinout of Connector Block on Host Board
© Finisar Corporation February 24, 2007 Rev. H
Page 2