Filtering
In some circuits which are sensitive to noise
TYPICAL CHARACTERISTICS
and ripple, a filtering capacitor may be added to
the DC/DC output end and input end to reduce
the noise and ripple. However, the capacitance
of the output filter capacitor must be proper. If the
capacitance is too big, a startup problem might
arise. For every channel of output, provided the
safe and reliable operation is ensured, the
greatest capacitance of its filter capacitor sees
the external capacitor table.
EXTERNAL CAPACITOR TABLE
Cin
(uF)
4.7
V in
(VDC)
Vout
(VDC)
Cout
(uF)
Operating Temp.(oC)
5
12
24
--
5
9
4.7
2.2
1
2.2
1
12
15
OUTLINE DIMENSIONS& PIN CONNECTION
--
0.47
It’s not recommended to connect any external capacitor
in the application field with less than 0.5 watt output。
To get an extremely low ripple, an “LC” filtering
network may be connected to the input and
output ends of the DC/DC converter, which may
First Angle Projection
RECOMMENDED FOOTPRINT
Top view,grid:2.54mm(0.1inch)
dia meter:1.00mm(0.039inch)
1
2
4
5
6
produce
a more significant filtering effect. It
1.9
should also be noted that the inductance and the
frequency of the “LC” filtering network should be
staggered with the DC/DC frequency to avoid
mutual interference (Figure 1).
(0.075)
1
2
4
5
6
L
L
+Vo
Vin
C
C
0V
DC DC
L
C
GND
FOOT PRINT DETAILS
-Vo
Pin
1
Functions
Vin
(Figure 1)
(0.020)
Output Voltage Regulation and Over-voltage
Protection Circuit
2
GND
Note:
Unit:mm(inch)
Pin section:0.50*0.3mm(0.020*0.012inch)
Pin tolerances: 0.10mm( 0.004inch)
Generaltolerances: 0.25mm( 0.010inch)
4
The simplest device for output voltage
5
regulation,
over-voltage
and
over-current
+
+
6
+Vo
+
+
protection is
a
linear voltage regulator with
overheat protection that is connected to the input
or output end in series (Figure 2).
APPLICATION NOTE
+Vout
Vin
REG
Requirement on output load
0V
DC DC
GND
To ensure this module can operate efficiently and reliably, a minimum load is specified for
this kind of DC/DC converter in addition to a maximum load (namely full load). During
operation, make sure the specified range of input voltage is not exceeded, the minimum
output load is not less than 10% of the full load, and that this product should never be
operated under no load! If the actual output power is very small, please connect a
resistor with proper resistance at the output end in parallel to increase the load, or use our
company’s products with a lower rated output power.
-Vout
REG
REG
+Vout
Vin
0V
DC DC
(Figure2)
No parallel connection or plug and play.
GND
-Vout
Overload Protection
Under normal operating conditions, the output circuit of these products has no protection
against over-current and short-circuits. The simplest method is to connect a self-recovery
fuse in series at the input end or add a circuit breaker to the circuit.
MORNSUN reserves the copyright
Specifications subject to change without notice.
E_M-1W A/0-2008
Page 2 of 2