DSA1001/3/4
1.0
ELECTRICAL CHARACTERISTICS
Absolute Maximum Ratings †
Input Voltage (VIN) ............................................................................................................................–0.3V to VDD + 0.3V
ESD Protection ....................................................................................................... 4 kV HBM, ±200V MM, 1.5 kV CDM
Recommended Operating Conditions
Supply Voltage (VDD) ................................................................................................................................ +1.7V to +3.6V
Output Load (ZL)............................................................................................................................. R > 10 kΩ, C ≤ 15 pF
† Notice: Stresses above those listed under “Absolute Maximum Ratings” may cause permanent damage to the device.
This is a stress rating only and functional operation of the device at those or any other conditions above those indicated
in the operational sections of this specification is not intended. Exposure to maximum rating conditions for extended
periods may affect device reliability.
TABLE 1-1:
ELECTRICAL CHARACTERISTICS
Electrical Characteristics: VDD = 1.8 to 3.3V; TA = +85°C unless otherwise specified.
Parameters
Frequency
Sym.
Min.
Typ.
Max.
Units
MHz Single Frequency
Includes frequency variations
Conditions
F0
1
—
—
—
—
—
—
150
±20
±25
±50
±5
—
—
—
—
—
due to initial tolerance,
temperature and power supply
voltage
Frequency Tolerance
Δf
ppm
Aging
Δf
ppm
µA
1 year @ +25°C
T = +25°C
Supply Current, Standby
IDD
15
Output Startup Time
(Note 1)
tSU
—
1.0
1.3
ms
T = +25°C
Output Disable Time
Output Duty Cycle
Input Logic Level High
Input Logic Level Low
VDD = 1.8V
tDA
SYM
VIH
—
45
20
—
—
—
100
55
ns
%
V
—
—
—
—
0.75 x VDD
—
—
VIL
0.25 x VDD
V
—
6.0
6.5
7.2
8.3
—
6.3
7.1
1 MHz
CL = 0 pF,
27 MHz
—
Supply Current, No Load
IDD
mA
RL = ∞,
T = +25°C
—
—
8.5
70 MHz
11.9
150 MHz
0.8 x VDD
0.8 x VDD
0.8 x VDD
—
—
V
V
V
V
V
V
–6 mA, DSA1004, CL = 40 pF
–6 mA, DSA1003, CL = 25 pF
–4 mA, DSA1001, CL = 15 pF
6 mA, DSA1004, CL = 40 pF
6 mA, DSA1003, CL = 25 pF
6 mA, DSA1001, CL = 15 pF
Output Logic Level High
Output Logic Level Low
VOH
—
—
—
—
—
0.2 x VDD
0.2 x VDD
0.2 x VDD
VOL
—
—
—
—
Note 1: tSU is time to stable output frequency after VDD is applied. tSU and tEN (after EN is asserted) are identical
values.
2: Measured over 50k clock cycles.
2017 Microchip Technology Inc.
DS20005889A-page 3