5秒后页面跳转
DS2404S-001 PDF预览

DS2404S-001

更新时间: 2024-01-31 19:18:52
品牌 Logo 应用领域
达拉斯 - DALLAS 光电二极管外围集成电路
页数 文件大小 规格书
28页 659K
描述
Real Time Clock, 0 Timer(s), CMOS, PDSO16,

DS2404S-001 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Obsolete零件包装代码:SOIC
包装说明:SOP,针数:16
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.72
最大时钟频率:0.032 MHz信息访问方法:SERIAL, 3-WIRE
JESD-30 代码:R-PDSO-G16JESD-609代码:e3
长度:10.3 mm湿度敏感等级:1
端子数量:16计时器数量:
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:SOP
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
峰值回流温度(摄氏度):260认证状态:Not Qualified
座面最大高度:2.65 mm最大供电电压:5.5 V
最小供电电压:4.5 V标称供电电压:5 V
表面贴装:YES技术:CMOS
温度等级:INDUSTRIAL端子面层:Matte Tin (Sn)
端子形式:GULL WING端子节距:1.27 mm
端子位置:DUAL处于峰值回流温度下的最长时间:NOT SPECIFIED
宽度:7.5 mmuPs/uCs/外围集成电路类型:TIMER, REAL TIME CLOCK
Base Number Matches:1

DS2404S-001 数据手册

 浏览型号DS2404S-001的Datasheet PDF文件第22页浏览型号DS2404S-001的Datasheet PDF文件第23页浏览型号DS2404S-001的Datasheet PDF文件第24页浏览型号DS2404S-001的Datasheet PDF文件第25页浏览型号DS2404S-001的Datasheet PDF文件第26页浏览型号DS2404S-001的Datasheet PDF文件第27页 
DS2404  
NOTES:  
1. All voltages are referenced to ground.  
2. VIH = 2.0V or VIL = 0.8V with 10 ns maximum rise and fall time.  
3. VDQH = 2.4V and VDQL = 0.4V, respectively.  
4. Load capacitance = 50 pF.  
5. Measured with outputs open.  
6. When battery is applied to VBATO input, VCC and VBATB must be 0V.  
7. VBATB , or VBATO = 3.0V; all inputs inactive state.  
8. Capacitance on the I/O pin could be 800 pF when power is first applied. If a 5kW resistor is used to  
pullup the I/O line to VPUP , 5 ms after power has been applied, the parasite capacitance will not affect  
normal communications.  
9. For auto-mode operation of the interval timer, the high level on the I/O pin must be greater than or  
equal to 70% of VCC or VBATO  
.
10. Read and write scratchpad (all 32 bytes) at 3.0V.  
11. All other inputs at CMOS levels.  
12. VPUP = external pullup voltage.  
13. Input load is to ground.  
14. An additional reset or communication sequence cannot begin until the reset high time has expired.  
15. Read data setup time refers to the time the host must pull the I/O line low to read a bit. Data is  
guaranteed to be valid within 1 ms of this falling edge.  
16. Under certain low voltage conditions VIL1MAX may have to be reduced to as much as 0.5V to always  
guarantee a presence pulse.  
17. Applies to 1Hz and IRQ pins only.  
18. Applies to DQ pin only.  
19. Applies to DQ, 1Hz and IRQ pins only.  
20. The reset low time (tRSTL ) should be restricted to a maximum of 960 ms, to allow interrupt signaling,  
otherwise, it could mask or conceal interrupt pulses.  
21. When the battery is attached, the oscillator powers up in the off state.  
28 of 28  
020998  

与DS2404S-001相关器件

型号 品牌 描述 获取价格 数据表
DS2404S-001+ MAXIM Real Time Clock, 0 Timer(s), CMOS, PDSO16, 0.300 INCH, ROHS COMPLIANT, SOIC-16

获取价格

DS2404S-001+T&R MAXIM Real Time Clock, 0 Timer(s), CMOS, PDSO16, 0.300 INCH, ROHS COMPLIANT, SOIC-16

获取价格

DS2404S-C01 DALLAS Dual Port Memory Plus Time

获取价格

DS2405 DALLAS Addressable Switch

获取价格

DS2405/R DALLAS Addressable Switch

获取价格

DS2405/T DALLAS Addressable Switch

获取价格