5秒后页面跳转
DS1825U+ PDF预览

DS1825U+

更新时间: 2024-01-27 12:10:56
品牌 Logo 应用领域
美信 - MAXIM 模拟IC信号电路光电二极管
页数 文件大小 规格书
21页 286K
描述
Programmable Resolution 1-Wire Digital Thermometer With 4-Bit ID

DS1825U+ 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:SOIC
包装说明:TSSOP,针数:8
Reach Compliance Code:compliantECCN代码:EAR99
HTS代码:8542.39.00.01Factory Lead Time:6 weeks
风险等级:0.94Samacsys Description:Board Mount Temperature Sensors Programmable Resolution 1-Wire Digital Thermometer With 4-Bit ID
模拟集成电路 - 其他类型:ANALOG CIRCUITJESD-30 代码:S-PDSO-G8
JESD-609代码:e3长度:3 mm
湿度敏感等级:1功能数量:1
端子数量:8最高工作温度:125 °C
最低工作温度:-55 °C封装主体材料:PLASTIC/EPOXY
封装代码:TSSOP封装形状:SQUARE
封装形式:SMALL OUTLINE, THIN PROFILE, SHRINK PITCH峰值回流温度(摄氏度):260
认证状态:Not Qualified座面最大高度:1.1 mm
最大供电电压 (Vsup):3.7 V最小供电电压 (Vsup):3 V
表面贴装:YES温度等级:MILITARY
端子面层:Matte Tin (Sn)端子形式:GULL WING
端子节距:0.65 mm端子位置:DUAL
处于峰值回流温度下的最长时间:30宽度:3 mm

DS1825U+ 数据手册

 浏览型号DS1825U+的Datasheet PDF文件第1页浏览型号DS1825U+的Datasheet PDF文件第2页浏览型号DS1825U+的Datasheet PDF文件第3页浏览型号DS1825U+的Datasheet PDF文件第5页浏览型号DS1825U+的Datasheet PDF文件第6页浏览型号DS1825U+的Datasheet PDF文件第7页 
DS1825 Programmable Resolution 1-Wire Digital Thermometer With 4-Bit ID  
OVERVIEW  
Figure 1 shows a block diagram of the DS1825, and pin descriptions are given in Table 1. The 64-bit ROM stores  
the device’s unique serial code. The scratchpad memory contains the 2-byte temperature register that stores the  
digital output from the temperature sensor. In addition, the scratchpad provides access to the 1-byte upper and  
lower alarm trigger registers (TH and TL), and the 1-byte configuration register. The configuration register allows the  
user to set the resolution of the temperature-to-digital conversion to 9, 10, 11, or 12 bits. It is also used for the hard-  
wired address programmed by the AD0-AD3 pins. The TH, TL, and configuration registers are NV (EEPROM), so  
they will retain data when the device is powered down.  
The DS1825 uses Dallas’ exclusive 1-Wire bus protocol that implements bus communication using one control  
signal. The control line requires a weak pullup resistor since all devices are linked to the bus through a 3-state or  
open-drain port (the DQ pin in the case of the DS1825). In this bus system, the microprocessor (the master device)  
identifies and addresses devices on the bus using each device’s unique 64-bit code. Because each device has a  
unique code, the number of devices that can be addressed on one bus is virtually unlimited. The 1-Wire bus  
protocol, including detailed explanations of the commands and “time slots,” is covered in the 1-Wire BUS SYSTEM  
section of this data sheet.  
Another feature of the DS1825 is the ability to operate without an external power supply. Power is instead supplied  
through the 1-Wire pullup resistor through the DQ pin when the bus is high. The high bus signal also charges an  
internal capacitor (CPP), which then supplies power to the device when the bus is low. This method of deriving  
power from the 1-Wire bus is referred to as “parasite power.” As an alternative, the DS1825 can also be powered  
by an external supply on VDD.  
Figure 1. DS1825 BLOCK DIAGRAM  
VPULLUP  
4.7k  
Memory  
DQ  
Control Logic  
Parasite  
Power  
Circuit  
16-bit Temp Reg  
8-bit TH Register  
8-bit TL Register  
8-bit CRC Gen  
S
C
R
A
T
64-Bit ROM  
And  
GND  
Cpp  
1-wire Port  
C
P
A
D
Power  
Supply  
Sense  
VDD  
8-bit Config. Reg  
Address Pin  
Input Latch  
AD0-AD3  
4 of 21  

与DS1825U+相关器件

型号 品牌 描述 获取价格 数据表
DS1825U+TR MAXIM Programmable Resolution 1-Wire Digital Thermometer With 4-Bit ID

获取价格

DS1825UTR MAXIM Programmable Resolution 1-Wire Digital Thermometer With 4-Bit ID

获取价格

DS1830 DALLAS Reset Sequence Pushbutton

获取价格

DS1830 MAXIM Power Supply Support Circuit, Adjustable, 1 Channel, PDIP8,

获取价格

DS1830 ADI 顺序复位按钮

获取价格

DS1830+ MAXIM Power Supply Support Circuit, Fixed, 1 Channel, PDIP8, 0.300 INCH, DIP-8

获取价格