DLO32F
APPLICATION NOTES
THERMAL STABILITY
POWER SUPPLY BYPASSING
The delay line used internally to develop the clock
signals in the DLO32F has a thermal coefficient
of 100ppm/C. For low frequency units, this is also
the thermal coefficient of the output frequency.
For higher frequency units, however, other
internal effects must be considered, and the
actual thermal coefficient may be somewhat
higher.
The DLO32F relies on a stable power supply to
produce a repeatable frequency within the stated
tolerances. A 0.1uf capacitor from VCC to GND,
located as close as possible to the VCC pin, is
recommended. A wide VCC trace and a clean
ground plane should be used.
DEVICE SPECIFICATIONS
TABLE 1: ABSOLUTE MAXIMUM RATINGS
PARAMETER
DC Supply Voltage
Input Pin Voltage
Storage Temperature
Lead Temperature
SYMBOL
VCC
VIN
TSTRG
TLEAD
MIN
-0.3
-0.3
-55
MAX
7.0
VDD+0.3
150
UNITS NOTES
V
V
C
300
C
10 sec
TABLE 2: DC ELECTRICAL CHARACTERISTICS
(0C to 70C, 4.75V to 5.25V)
PARAMETER
SYMBOL
MIN
TYP
MAX
UNITS
NOTES
High Level Output Voltage
VOH
2.5
3.4
V
VCC = MIN, IOH = MAX
VIH = MIN, VIL = MAX
VCC = MIN, IOL = MAX
VIH = MIN, VIL = MAX
Low Level Output Voltage
VOL
0.35
0.5
V
High Level Output Current
Low Level Output Current
High Level Input Voltage
Low Level Input Voltage
Input Clamp Voltage
Input Current at Maximum
Input Voltage
High Level Input Current
Low Level Input Current
Short-circuit Output Current
Output High Fan-out
IOH
IOL
VIH
VIL
VIK
IIHH
-1.0
20.0
mA
mA
V
V
V
2.0
-60
0.8
-1.2
0.1
VCC = MIN, II = IIK
VCC = MAX, VI = 7.0V
mA
IIH
IIL
IOS
20
-0.6
-150
25
VCC = MAX, VI = 2.7V
VCC = MAX, VI = 0.5V
VCC = MAX
mA
mA
mA
Unit
Load
Output Low Fan-out
12.5
TABLE 3: AC ELECTRICAL CHARACTERISTICS
(0C to 70C, 4.75V to 5.25V)
PARAMETER
SYMBOL MIN TYP MAX
UNITS
Enable to Clock On (Inherent Delay)
Disable to Clock Off
Clock Skew
tEO
tDO
tCS
tGR
1.5
1.5
1.5
50
3.0
2.5
2.5
4.5
3.5
3.5
ns
ns
ns
Gate Recovery Time
% of Clock Period
Doc #98002
3/17/98
DATA DELAY DEVICES, INC.
Tel: 973-773-2299 Fax: 973-773-9672 http://www.datadelay.com
2