15 Watts
xppower.com
DLE Series
•
•
•
•
•
•
•
AC Input LED Driver
Constant Voltage & Current Versions
High Power Factor
High Efficiency
Water Proof to IP67
Class 2
3 Year Warranty
Specification
Input
General
Input Voltage
Input Frequency
Input Current
Inrush Current
Power Factor
• 90-264 VAC, see derating curve
• 47-63 Hz
• 0.25 A at 115 VAC, 0.1 A at 230 VAC
• 15 A at 230 VAC, cold start +25 °C
• >0.83 at 230 VAC, full load
Efficiency
• See table
• 3750 VAC Input to Output
• 100 kHz typical
Isolation
Switching Frequency
MTBF
• >200 kHrs to MIL-HDBK-217F at 25 °C, GB
Environmental
No Load Input Power • <0.5 W max at 230 VAC
Input Protection
• Internal T1.0A/250V fuse fitted in line
Operating Temperature • -20 °C to +70 °C (see derating curve)
Operating Humidity • 5-100% RH, non-condensing
Storage Temperature • -40 °C to +80 °C
Output
Operating Altitude
Vibration
• 3000 m
Output Voltage
Minimum Load
Start Up Delay
Hold Up Time
• See table
• No min load required
• 500 ms max at 115 VAC
• No hold up for -A versions,
6ms min for -V versions
• 10-500 Hz, 2 g, 10 mins/cycle, 6 cycles in
each of 3 axes
EMC & Safety
Emissions
• EN55015, class B conducted and radiated
• EN61000-3-2, class C
• EN61000-3-3
• EN61000-4-2, 8 kV air and 4 kV contact,
Perf Criteria A
Line Regulation
Load Regulation
•
•
0.5%
Harmonic Currents
Voltage Flicker
ESD Immunity
1.0% in constant voltage mode,
5.0% in constant current mode
Turn On Overshoot
Transient Response
• 5% max
• 5% max deviation, recovery to within 1%
in 10 ms for a 50% load change
• 1% max mV pk-pk, for - V versions
(see note 2)
Radiated Immunity
EFT/Burst
• EN61000-4-3, level 2 Perf Criteria A
• EN61000-4-4, level 2 Perf Criteria A
Ripple & Noise
Surge
• EN61000-4-5, installation class 3,
Perf Criteria B
Overload Protection
• 130-160% for -V versions, auto recovery
Conducted Immunity
Dips & Interruptions
• EN61000-4-6, level 2 Perf Criteria A
• EN61000-4-11, 100% 10 ms,
30% 200 ms, Perf Criteria B, B
Short Circuit Protection • Trip and restart (hiccup mode)
Temperature
Coefficient
• 0.04%/°C
Safety Approvals
• EN61347, UL8750, CE Mark