5秒后页面跳转
CAT5110TBI-00-T PDF预览

CAT5110TBI-00-T

更新时间: 2024-01-07 22:56:54
品牌 Logo 应用领域
CATALYST 转换器电位器数字电位计光电二极管
页数 文件大小 规格书
11页 166K
描述
32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface

CAT5110TBI-00-T 技术参数

是否无铅: 不含铅是否Rohs认证: 符合
生命周期:Active零件包装代码:SOT-23
包装说明:VSSOP,针数:6
Reach Compliance Code:compliant风险等级:5.12
Is Samacsys:N控制接口:INCREMENT/DECREMENT
转换器类型:DIGITAL POTENTIOMETERJESD-30 代码:R-PDSO-G6
JESD-609代码:e3长度:2.9 mm
湿度敏感等级:1功能数量:1
位置数:32端子数量:6
最高工作温度:85 °C最低工作温度:-40 °C
封装主体材料:PLASTIC/EPOXY封装代码:VSSOP
封装形状:RECTANGULAR封装形式:SMALL OUTLINE, VERY THIN PROFILE, SHRINK PITCH
峰值回流温度(摄氏度):260认证状态:Not Qualified
电阻定律:LINEAR座面最大高度:1 mm
标称供电电压:2.7 V表面贴装:YES
标称温度系数:200 ppm/ °C温度等级:INDUSTRIAL
端子面层:MATTE TIN端子形式:GULL WING
端子节距:0.95 mm端子位置:DUAL
处于峰值回流温度下的最长时间:40标称总电阻:100000 Ω
宽度:1.6 mmBase Number Matches:1

CAT5110TBI-00-T 数据手册

 浏览型号CAT5110TBI-00-T的Datasheet PDF文件第4页浏览型号CAT5110TBI-00-T的Datasheet PDF文件第5页浏览型号CAT5110TBI-00-T的Datasheet PDF文件第6页浏览型号CAT5110TBI-00-T的Datasheet PDF文件第8页浏览型号CAT5110TBI-00-T的Datasheet PDF文件第9页浏览型号CAT5110TBI-00-T的Datasheet PDF文件第10页 
CAT5110/5118/5119  
FUNCTIONAL DESCRIPTION  
The CAT5110/5118/5119 consist of a fixed resistor and  
a wiper contact with 32-tap points that are digitally  
controlled through a 2-wire up/down serial interface.  
Threeend-to-endresistancevaluesareavailable:10k,  
50kand 100k.  
The CS and U/D inputs control the position of the wiper  
along the resistor array. When CS transitions from high  
to low, the part will go into increment mode if U/D input  
is high, and into decrement mode when U/D input is low.  
Oncethemodeisset, thedevicewillremaininthatmode  
until CS goes high again. A low-to-high transition at the  
U/D pin will increment or decrement the wiper position  
depending on the current mode (Figures 1 and 2).  
TheCAT5110isdesignedtooperateasapotentiometer.  
Inthisconfiguration, thelowterminaloftheresistorarray  
is connected to ground (pin 2).  
When the CS input transitions to high (serial interface  
inactive), the value of the counter is stored and the wiper  
position is maintained.  
The CAT5118 performs as a variable resistor. In this  
device, the wiper terminal and high terminal of the  
resistor array is connected at pin 5. The CAT5119 is a  
similar variable resistor, except the low terminal is  
connected to pin 5.  
Note that when the wiper reaches the maximum (or  
minimum) tap position, the wiper will not wrap around to  
the minimum (or maximum) position.  
Digital Interface Operation  
Power-On Reset  
The Minipots have two modes of operation when the  
serial interface is active: increment and decrement  
mode. The serial interface is only active when CS is  
low.  
All parts in this family feature power-on reset (POR)  
circuitry that sets the wiper position to midscale at  
power-up. By default, the chip is in the increment mode.  
Figure 1. Serial Interface Timing Diagram, Increment Mode  
CS  
t
CU  
t
IC  
t
IL  
U/D  
t
t
IH  
CI  
t
SETTLE  
t
SETTLE  
W
Note: "W" is not a digital signal. It represents wiper transitions.  
Figure 2. Serial Interface Timing Diagram, Decrement Mode  
CS  
t
t
IC  
CU  
t
IH  
U/D  
t
IL  
t
CI  
W
t
SETTLE  
t
SETTLE  
Note: "W" is not a digital signal. It represents wiper transitions.  
Doc. No. 2120, Rev. A  
7

与CAT5110TBI-00-T相关器件

型号 品牌 描述 获取价格 数据表
CAT5110TBI00-T ONSEMI 100K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 32 POSITIONS, PDSO6, SO

获取价格

CAT5110TBI-00-T10 CATALYST 32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface

获取价格

CAT5110TBI-00-T10 ONSEMI 100K DIGITAL POTENTIOMETER, INCREMENT/DECREMENT CONTROL INTERFACE, 32 POSITIONS, PDSO6, RO

获取价格

CAT5110TBI-00T3 CATALYST 32-Tap MiniPot⑩ Digitally Programmable Potent

获取价格

CAT5110TBI-00-T3 ONSEMI 32-Tap MiniPot Digitally Programmable Potentiometers with 2-Wire Interface

获取价格

CAT5110TBI-00-T3 CATALYST 32-Tap MiniPot TM Digitally Programmable Potentiometers with 2-Wire Interface

获取价格