ATF22V10B
Input Test Waveforms and
Measurement Levels
Output Test Loads
Commercial
Military
tR, tF < 3 ns
* All except -7 which is R2 = 300Ω
Pin Capacitance
f = 1 MHz, T = 25°C(1)
Typ
5
Max
8
Units
pF
Conditions
CIN
VIN = 0V
COUT
6
8
pF
VOUT = 0V
Note:
1. Typical values for nominal supply voltage. This parameter is only sampled and is not 100% tested.
Power-up Reset
The registers in the ATF22V10Bs are designed to reset
during power-up. At a point delayed slightly from VCC cross-
ing VRST, all registers will be reset to the low state. The
output state will depend on the polarity of the output buffer.
This feature is critical for state machine initialization. How-
ever, due to the asynchronous nature of reset and the
uncertainty of how VCC actually rises in the system, the
following conditions are required:
1. The VCC rise must be monotonic,
2. After reset occurs, all input and feedback setup times
must be met before driving the clock pin high, and
Parameter
Description
Typ
Max
Units
3. The clock must remain stable during tPR
.
Power-up
Reset Time
tPR
600
1,000
ns
Preload of Registered Outputs
Power-up
Reset
Voltage
The ATF22V10B’s registers are provided with circuitry to
allow loading of each register with either a high or a low.
This feature will simplify testing since any state can be
forced into the registers to control test sequencing. A
JEDEC file with preload is generated when a source file
with vectors is compiled. Once downloaded, the JEDEC file
preload sequence will be done automatically by most of the
approved programmers after the programming.
VRST
3.8
4.5
V
Security Fuse Usage
A single fuse is provided to prevent unauthorized copying
of the ATF22V10B fuse patterns. Once programmed, fuse
verify and preload are inhibited. However, the 64-bit User
Signature remains accessible.
The security fuse should be programmed last, as its effect
is immediate.
5