Functional Data I/O
Caution
The AFBR-59R5LZ interfaces with the host circuit board
through fourteen I/O pins (2x7) identified by function
in Table 2. These pins are sized for the use in boards be-
tween 0.062 in. and 0.100 in. thick. The board layout for
this interface is depicted in Figure 7.
There are no user serviceable parts nor maintenance
requirements for the AFBR-59R5LZ. All mechanical
adjustments are made at the factory before shipping.
Tampering with, modifying, misusing or improperly han-
dling the AFBR-59R5LZ will void the product warranty.
It may also result in improper operation and possibly
overstress the laser source. Performance degradation
or device failure may result. Connection of the AFBR-
59R5LZ to a light source not compliant to IEEE 802.3 or
ANSI FC-PI specifications, operating above the maximum
operating conditions or in a manner inconsistent with it’s
design and function may result in exposure to hazardous
light radiation and may constitute an act of modifying or
manufacturing a laser product.
The AFBR-59R5LZ transmit and receive interfaces are
PECL compatible. To simplify board requirements,
transmitter bias resistors and ac coupling capacitors are
incorporated into the transceiver module and so are not
required on the host board. The Tx_Disable and Signal
Detect lines require TTL lines on the host board if they
are to be utilized. The transceiver will operate normally if
these lines are not connected on the host board.
Figure 2 depicts the recommended interface circuit to
link the AFBR-59R5LZ to the supporting physical layer
ICs. Timing for MSA compliant control signals imple-
mented in the transceiver are listed on Page 12 and
diagramed in Figure 5.
Persons performing such an act are required by law to
re-certify and re-identify the laser product under the
provisions of U.S. 21 CFR (Subchapter J) and the TUV.
Ordering Information
PCB Assembly Process Compatibility
Please contact your local field sales engineer or one of
Avago Technologies franchised distributors for ordering
information. For technical information, please visit Ava-
go Technologies’ WEB page at www.avagotech.com or
contact Avago Technologies Customer Response Center
at 1-800-235-0312. For information related to SFF Com-
mittee documentation visit www.sffcommittee.org
The AFBR-59R5LZ is compatible with industry standard
wave solder and aqueous wash processes as detailed on
Page 13. The transceiver is shipped with a process plug
to keep out impinging liquids, but is not intended to be
immersed. After assembly, the process plug should be
kept in place as a dust plug when the transceiver is not
in use.
4