5秒后页面跳转
AD83C154T-36 PDF预览

AD83C154T-36

更新时间: 2022-10-09 09:20:41
品牌 Logo 应用领域
TEMIC 微控制器
页数 文件大小 规格书
24页 242K
描述
CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller

AD83C154T-36 数据手册

 浏览型号AD83C154T-36的Datasheet PDF文件第2页浏览型号AD83C154T-36的Datasheet PDF文件第3页浏览型号AD83C154T-36的Datasheet PDF文件第4页浏览型号AD83C154T-36的Datasheet PDF文件第6页浏览型号AD83C154T-36的Datasheet PDF文件第7页浏览型号AD83C154T-36的Datasheet PDF文件第8页 
80C154/83C154  
ALE  
XTAL1  
Address Latch Enable output for latching the low byte of  
the address during accesses to external memory. ALE is  
activated as though for this purpose at a constant rate of  
1/6 the oscillator frequency except during an external  
data memory access at which time one ALE pulse is  
skipped. ALE can sink or source 8 LS TTL inputs. It can  
drive CMOS inputs without an external pullup.  
Input to the inverting amplifier that forms the oscillator.  
Receives the external oscillator signal when an external  
oscillator is used.  
XTAL2  
Output of the inverting amplifier that forms the oscillator,  
and input to the internal clock generator. This pin should  
be floated when an external oscillator is used.  
PSEN  
Program Store Enable output is the read strobe to external  
Program Memory. PSEN is activated twice each machine  
cycle during fetches from external Program Memory.  
(However, when executing out of external Program  
Memory, two activations of PSEN are skipped during  
each access to external Data Memory). PSEN is not  
activated during fetches from internal Program Memory.  
PSEN can sink/source 8 LS TTL inputs. It can drive  
CMOS inputs without an external pullup.  
EA  
When EA is held high, the CPU executed out of internal  
Program Memory (unless the Program Counter exceeds  
3FFFH). When EA is held low, the CPU executes only out  
of external Program Memory. EA must not be floated.  
Idle and Power Down Operation  
Figure 3 shows the internal Idle and Power Down clock  
configuration. As illustrated, Power Down operation  
stops the oscillator. The interrupt, serial port, and timer  
blocks continue to function only with external clock  
(INT0, INT1, T0, T1).  
Idle Mode operation allows the interrupt, serial port, and  
timer blocks to continue to function with internal or  
external clocks, while the clock to CPU is gated off. The  
special modes are activated by software via the Special  
Function Register, PCON. Its hardware address is 87H.  
PCON is not bit addressable.  
Figure 3. Idle and Power Down Hardware.  
MATRA MHS  
5
Rev.F (14 Jan. 97)  

与AD83C154T-36相关器件

型号 品牌 描述 获取价格 数据表
AD83C154T-L16 TEMIC CMOS 0 to 36 MHz Single Chip 8-bit Microcontroller

获取价格

AD83C154TXXX-12 ATMEL Microcontroller, 8-Bit, MROM, 12MHz, CMOS, CDIP40,

获取价格

AD83C154TXXX-12D ATMEL Microcontroller, 8-Bit, MROM, 12MHz, CMOS, CDIP40, 0.600 INCH, CERAMIC, DIP-40

获取价格

AD83C154TXXX-16 TEMIC Microcontroller, 8-Bit, MROM, 16MHz, CMOS, CDIP40,

获取价格

AD83C154TXXX-16D TEMIC Microcontroller, 8-Bit, MROM, 16MHz, CMOS, CDIP40,

获取价格

AD83C154TXXX-20 TEMIC Microcontroller, 8-Bit, MROM, 20MHz, CMOS, CDIP40,

获取价格