Product specification
4
12
SERIES
0201 to 2512
AC
Chip Resistor Surface Mount
CONSTRUCTION
The resistors are constructed on top of an automotive grade ceramic body. Internal metal electrodes are added at
each end and connected by a resistive glaze. The resistive glaze is covered by a protective glass.
The composition of the glaze is adjusted to give the approximately required resistance value and laser trimming of this
resistive glaze achieves the value within tolerance. The whole element is covered by a protective overcoat. Size 0603 and
bigger is marked with the resistance value on top. Finally, the two external terminations (Ni / matte tin) are added, as
shown in Fig.8.
OUTLINES
marking layer
overcoat
marking layer
overcoat
protective glass
protective glass
resistive layer
(Jumper chip is a conductor)
resistive layer
(Jumper chip is a conductor)
inner electrode
inner electrode
termination(Ni/matte tin)
inner electrode
termination(Ni/matte tin)
inner electrode
ceramic substrate
ceramic substrate
YNSC088
YNSC08
8_1
Fig. 8_2 AC2010/ 2512 double power chip resistor outlines
Fig. 8_1 Chip resistor outlines
DIMENSIONS
Table 1 For outlines, please refer to Fig. 9
TYPE
L (mm)
W (mm)
H (mm)
I1 (mm)
I2 (mm)
AC0201
AC0402
AC0603
AC0805
AC1206
AC1210
AC1218
AC2010
AC2512
0.60±0.03
1.00 ±0.05
1.60 ±0.10
2.00 ±0.10
3.10 ±0.10
3.10 ±0.10
3.10 ±0.10
5.00 ±0.10
6.35 ±0.10
0.30±0.03
0.50 ±0.05
0.80 ±0.10
1.25 ±0.10
1.60 ±0.10
2.60 ±0.15
4.60 ±0.10
2.50 ±0.15
3.10 ±0.15
0.23±0.03
0.32 ±0.05
0.45 ±0.10
0.50 ±0.10
0.55 ±0.10
0.55 ±0.10
0.55 ±0.10
0.55 ±0.10
0.55 ±0.10
0.12±0.05
0.20 ±0.10
0.25 ±0.15
0.35 ±0.20
0.45 ±0.20
0.45 ±0.15
0.45 ±0.20
0.55 ±0.15
0.60 ±0.20
0.15±0.05
0.25 ±0.10
0.25 ±0.15
0.35 ±0.20
0.40 ±0.20
0.50 ±0.20
0.40 ±0.20
0.50 ±0.20
0.50 ±0.20
For dimension, please refer to Table 1
AC0201/0402
0603/0805/1206/1210/
2010/2512
AC1218
Side view for all type
Fig. 9 Chip resistor dimensions
www.yageo.com
Jun. 20, 2017 V.6