T6K18
TOSHIBA CMOS DIGITAL INTEGRATED CIRCUIT SILICON MONOLITHIC
T6K18
COLUMN AND ROW DRIVER LSI FOR A DOT MATRIX GRAPHIC LCD
The T6K18 is a driver for small−to−medium−sized dot matrix
Liquid Crystal Display (LCD). This driver combines the functions
of the T9841B (column driver) and T9842B (row driver) into a
Unit: mm
User Area Pitch
more functionally advanced single−chip device.
T6K18
The T6K18 can be interfaced with 8−bit general MPU; it operates
asynchronously with the MPU. The T6K18 contains an RC
oscillator circuit to generate the timing signal required for
display and has a built−in RAM to store the display data. Each
cell in this RAM corresponds to each dot on the dot matrix LCD.
Therefore, the display data written to the RAM is corresponded
one to one to the LCD as the LCD drive signal output. The T6K18
has 80 outputs for LCD drive signals (columns) that are
equivalent to display data and 26 outputs for LCD drive signals
(rows) that are equivalent to scan signals. Consequently, this
single chip can drive up to 80 × 26 dots of LCD display with
minimal power.
IN
OUT
0.26
(UAM, 5NS)
0.7
Please contact Toshiba or its distributor for
information about the latest TCP
specification and product lineup.
TCP (Tape Carrier Package)
In addition, the T6K18 has the LCD power supply regulator, a voltage quadrupler, and a contrast control circuit
enabling the LCD to be driven by a single power supply. To minimize current consumption in the oscillator, the
T6K18 has an oscillator regulator. The T6K18 has key scan circuit which can construct (max.) 32 (4 × 8) key
matrix.
Features
ꢀ
Built−in display RAM with 80 × 26 = 2080 bits of capacity.
ꢀ
Direct RAM data display
Dots are turned on when bit data in RAM = 1.
Dots are not turned on when bit data in RAM = 0.
ꢀ
ꢀ
ꢀ
Display duty cycle
: 1/26 or 1/18 duty (switchable)
Display data word length can be switched between 8 bits and 6 bits according to character font.
LCD display drive circuit
Segment output
Common output
: 80 lines
: 26 or 18 lines (switchable)
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Can be interfaced with 8−bit general MPU (operated asynchronously).
Data interface : Parallel data interface.
Built−in oscillator circuit regulator (oscillator unit only is operated with 1.7 V).
Key scan circuit : Able to construct max. 32 (4 × 8) key matrix.
Built−in RC oscillator (capacitor internal and resistor external to the chip)
T6K18 is able to switch to external clock input by software.
Built−in LCD power supply regulator, voltage quadrupler, and contrast control circuits
(16−gradation). (4.1 to 5.3 V, 0.08 V / step)
ꢀ
ꢀ
ꢀ
ꢀ
ꢀ
Low power consumption (10 µA during display without data access when operating at 3.0 V).
CMOS process.
Low−voltage operation : 1.8 to 5.5 V
Operating voltage of LCD drive signal
: (1) V4 = 4 times the LCD power supply regulator output V1.
(2) 1 / 4 bias
ꢀ
Package
: Bump chip and 148 pins TCP
1
2003-06-18