J-Type Medallion 6000 1550 nm
Externally Modulated Transmitter
DATASHEET | JULY 2012
FIBER OPTICS
Optical Characteristics
Property
Performance (note 1-8)
Specified Link Length
Units
Models
6000-J01 6000-J02
Comments
L (km)
25
25
With 36 QPSK carriers from 950 to
2800 MHz
Channel Plan
NTSC 80-Ch
PAL 60-Ch
Optical Output Power
Po (dBm)
BW (MHz)
(dBm)
8.5/8.5
4
8.5/8.5
5
Min. 10 dBm version avail. See Chart
Noise Bandwidth
SBS Suppression
15.0
51.0
-65
-65
-64
27
15.0
51.0
-65
-65
-64
27
Min.
CATV Carrier to Noise Ratio
CATV Composite Second Order
CATV Composite Triple Beat
CATV Composite Triple Beat
SAT-IF Carrier to Noise Ratio
SAT-IF Intermodulation Products
SAT-IF Spurious Products
CNR (dB)
CSO (dBc)
CTB (dBc)
CTB (dBc)
CNR (dB)
(dBc)
Min.
Max. Port 1
Max. @ +25C
Max. @ 0oC to 50oC
Min.
-35
-38
-35
-38
Max. Port 1
Max.
(dBc)
Notes:
1. Unless stated otherwise all specifications apply over full temperature range with no digital loading.
2. Unless stated otherwise specifications apply for nominal RF input level as defined below, after a 30 minute stabilization
period.
3. Specifications separated by a slash are port1 / port 2.
4. Units are tested per the Test / Link Configuration Table
5. Noise figure for the EDFA = 4.5 ~ 5.5 dB
6. Corning SMF-28 single mode fiber
7. Receiver responsivity is 0.95 mA/mW, Equivalent noise current is 7 pA/(Hz)1/2
8. With 36 QPSK modulated SAT-IF signals between 950 …2800 MHz. 27 MHz IF bandwidth
Test/Link Configuration
Property
EDFA
Link
Received Power2
J-Type
14 dBm
25 Km
0.0 dBm at the receiver
|
REV 2012.07
Information contained herein is deemed reliable and accurate as of the issue date. EMCORE reserves the right to change the design or specification at any time without notice.