IEC/ EN/ DIN EN 60747-5-2 Insulation Related Characteristics
Description
Symbol
PDIP Option 060
Units
Installation classification per DIN VDE 0110/ 1.89, Table 1
for rated mains voltage ≤150 V rms
for rated mains voltage ≤300 V rms
for rated mains voltage ≤600 V rms
I-IV
I-III
Climatic Classification
55/ 85/ 21
Pollution Degree (DIN VDE 0110/ 1.89)
Maximum Working Insulation Voltage
Input to Output Test Voltage, Method b*
2
V
630
Vpeak
Vpeak
IORM
V
IORM x 1.875 = V , 100% Production Test
V
1181
PR
PR
with tm = 1 sec, Partial Discharge < 5 pC
Input to Output Test Voltage, Method a*
V
IORM x 1.5 = V , Type and Sample Test,
V
945
Vpeak
Vpeak
PR
PR
tm = 60 sec, Partial Discharge < 5 pC
Highest Allowable Overvoltage*
V
6000
IOTM
(Transient Overvoltage, tini = 10 sec)
Safety Limiting Values
(See below for Thermal Derating Curve Figures)
Case Temperature
T
175
230
600
°C
mA
mW
S
Input Current
Output Power
IS,INPUT
PS,OUTPUT
Insulation Resistance at T , V = 500 V
R
≥109
Ω
S
IO
S
*Refer to the front of the optocoupler section of the current catalog, under Product Safety Regulations section IEC/ EN/ DIN/ EN 60747-5-2, for a
detailed description.
Note: Isolation characteristics are guaranteed only within the safety maximum ratings which must be ensured by protective circuits in application.
Absolute Maximum Ratings
Storage Temperature, TS ................................................ -55° C to +125° C
Operating Temperature, TA .............................................. -40° C to +85° C
Lead Solder Temperature, max ......................................... 260° C for 10 s
(1.6 mm below seating plane)
Average Input Current, IF ............................................................ 20 mA[1]
Peak Input Current, IF ...................................................................... 40 mA
(50% duty cycle, 1 ms pulse width)
Peak Transient Input Current, IF .......................................................1.0 A
(≤1 µs pulse width, 300 pps)
Reverse Input Voltage, VR ...................................................................... 5 V
Input Power Dissipation, PI ........................................................35 mW[2]
Output Current, IO (Pin 5)........................................................... 60 mA[3]
Emitter-Base Reverse Voltage (Pins 4-6) .......................................... 0.5 V
Output Voltage, VO (Pin 5-4)
4N45 ...........................................................................................-0.5 to 7 V
4N46 .........................................................................................-0.5 to 20 V
Output Power Dissipation......................................................... 100 mW[4]
Infrared and Vapor Phase Reflow Temperature
(Option #300) .............................................. see Fig. 1, Thermal Profile
6