Model 150D
Vishay Sprague
STANDARD REEL PACKAGING INFORMATION
1. Component Leads:
f. A row of components must be centered between tapes
0.047" [1.19mm]. In addition, individual components may
deviate from center of component row 0.031" [0.79mm].
a. Component leads shall not be bent beyond 0.047"
[1.19mm] maximum from their nominal position when
measured from the leading edge of the component lead
at the inside tape edge and at the lead egress from the
component.
g. Staples shall not be used for splicing. Not more than
4 layers of tape shall be used in any splice area and no
tape shall be offset from another by more than 0.031"
[0.79mm] non-cumulative. Tape splices shall overlap at
least 6.0" [152.4mm] for butt joints and at least 3.0"
[76.2mm] for lap joints and shall not be weaker than
unspliced tape. Universal splicing clips may also be used.
b. The 'C' dimension shall be governed by the overall
length of the reel packaged component. The distance
between flanges shall be 0.125" to 0.250" [3.18mm to
6.35mm] greater than the overall component length.
h. Quantity per reel shall be controlled so that tape compo
nents and cover shall not extend beyond the smallest
dimension of the flange (either across flats or diameter).
Once the quantity per reel for each part number has been
established, future orders for that part number shall be
packaged in that quantity. When order or release quantity
is less than the established quantity, a standard commercial
pack is to be used.
2. Orientation:
a. All polarized components must be oriented to one
direction. The cathode lead tape shall be a color and
the anode lead tape shall be white.
3. Reeling:
a. Components on any reel shall not represent more than
two date codes when date code identification is required.
i. A maximum of 0.25% of the components per reel quantity
may be missing without consecutive missing components.
b. Component leads shall be positioned between pairs of
0.250" [6.35mm] tape.
j. Adequate protection must be provided to prevent
physical damage to both reel and components during
shipment and storage.
c. The disposable reels have hubs and corrugated fiber
board flanges and core or equivalent.
d. A minimum of 12.0" [304.8mm] leader of tape shall be provided
before the first and after the last component on the reel.
4. Marking:
a. Minimum reel and carton marking shall consist of the
following: Customer Part Number, Purchase Order No.,
Quantity, Package Date, Manufacturer's Name, Electrical
Value, Date Code, Vishay Sprague Part Number and
Country of Origin.
e. 50 or 60 lb. Kraft paper must be wound between layer of
components as far as necessary for component protection.
Width of paper to be 0.062" to 0.250" [1.57mm to 6.35mm]
less than the 'C' dimension of the reel.
Document Number: 40015
Revision 12-Jan-01
www.vishay.com
23