Electrical and Mechanical Specifications
Terminal Information
Bushing Information
Insulated Construction (Standard)
Standard: 3/8"-32 UNEF-2A thread, .375" (9.53mm)
or .250" (6.35mm) long. M9 x 0.75
available.
The contactor is insulated from the base and
connected to the center terminal on the insulated
construction. This construction can be supplied
with the center terminal and one end terminal at
either end of the resistance element or with the
center terminal and terminals at both ends of the
resistance element.
Special: As required in increments of 1/16" (1.58mm)
Locating Lugs
Standard Position: Left side (with terminals down)
supplied, unless otherwise
specified.
Grounded Construction (Optional)
The grounded construction is supplied without a
center terminal and the contactor is connected to
the case. This construction can be furnished with
one end terminal at either end of the resistance
element or with terminals at both ends of the
element.
Other Positions:
Available with right side only, both
left and right, or without lugs.
CTS SERIES TYPE 118
CLEARANCE HOLE FOR 3/8-32 THREADED BUSHING
CENTER TERMINAL SUPPLIED WITH INSULATED CONTACT ARM CONSTRUCTION.
OMITTED ON GROUNDED CONTACT ARM CONSTRUCTION.
10.41
.410
10.41
.410
1.57
.062
1.57
.062
2.08
.082
4.16±0.05
.164±.002
3.96
.156
OPTIONAL PC TERMINAL POSTION
PERPENDICULAR TO MFG. SURFACE.
45°
45°
7.14
.281
END C.C.W
ROT.
END C.W
9.4±0.05
.370±.002
1.4
.055
1.52
.060
3/8-32 UNEF-2A
2.79±0.05
.110±.002
7.95
.313
40°
40°
TERMINLS 1.98/.078
WIDE X 0.40/.016
19.84
.781
6.35
.250
6.35
.250
270°
ROT.
LOCATING LUG
11.13
.438
2.03±0.38
.080±.015
1.60
.063
11.13
.438
0.4
.016
A±
ABOVE MFG SURFACE
0.8
.031
L±
mm
DIMENSION:
INCH
Ordering Information
118 G A 3 32 R
103
B 1
TAPER
1 – LINEAR
LOCATING
LUG
SHAFT TRIM
RESIST TOLERANCE
R – ROUND
1 –LEFT
2 –RIGHT
3 –NONE
F – FLATTED
K – KNURLED
A– ±10%
B– ±20%
D– ± 5%
RESISTANCE CODE
CODE RESISTANCE
TERMINAL STYLE
SHAFT LENGTH
J – INSULATED
CONSTRUCTION
G –GROUNDED
CONSTRUCTION
5A0
500
101
501
102
252
502
103
203
5 OHMS
50
100
500
1K
2.5K
5K
10K
20K
118 SERIES ONLY
FROM MOUNTING SURFACE
1/32" INCREMENTS
20 – .625" (15.9mm)
24 – .750" (19.1mm)
28 – .875" (22.2mm)
32 – 1.000" (25.4mm)
MOUNTING STYLE BUSHING
A – 1/4" (6.35mm) LONG
B – 3/8" (9.53mm) LONG
Metric bushings available. Consult CTS.
9/30/06
2 - 2
© 2006 CTS Corporation. All rights reserved. Information subject to change.
CTS Electronic Components
www.ctscorp.com