JNPS-0814
6-3 ELECTRICAL SPECIFICATIONS
TEST
RELATED
REQUIREMENT
DESCRIPTION
TEST CONDITION
STANDARD
No appearance of arcing
and break down.
DIELECTRIC
WITHSTANDING
VOLTAGE
Impressed voltage is AC 500V rms.
between adjacent two contacts for one
minute.
――――
Leak current: 1mA Max.
500MΩ Min.
Less than 1µs
INSULATION
RESIDENSE
Impressed voltage is DC 500V between
adjacent two contacts for one minute.
――――
- Vibration test
DISCONTINUITY
* as the part of 3M SEQUENCE-II
- Mechanical sock test
See Table 1.
Initial /
Contact resistance is measured
at Short Circuit.
for each plating spec.
35mΩ Max.
Current: 1.5mA
Open Circuit Voltage: 20mV
by 4 terminal method.
* Measurement values include
the resistance of contact pins
as conductive material.
Change of contact
resistance after
(1) PL Plating
3M SEQUENCE -I /
mating (30 cycles) Æ moisture
Æ salt spray
evaluation tests/
for each plating spec.
± 25mΩ Max.
3M SEQUENCE -II /
thermal shock Æ humidity
Æ vibration
3M SEQUENCE -III /
thermal life
H2S GAS SEQUENCE /
mating (30 cycles)Æ H2S gas
DURABILITY /
CONTACT
See Table 1.
300 cycles
RESISTANCE
MECHANICAL SHOCK /
(2) PE Plating and PC Plating
3M SEQUENCE -I /
mating (50 cycles) Æ moisture
Æ salt spray
3M SEQUENCE -II /
thermal shock Æ humidity
Æ vibration
3M SEQUENCE -III /
thermal life
H2S GAS SEQUENCE /
mating (50 cycles)Æ H2S gas
DURABILITY /
500 cycles
* NOTE: See Table 1.
for environmental tests.
9