Instruction Sheet
Application and Maintenance for Crimping
Die Assemblies for Tape-Mounted PIDG*
and PLASTI-GRIP* Terminals and Splices
408-2423
08 APR 14 Rev B
Die Holding
Screw
Moving Die
Wire Barrel
Crimper
Saddle Screw
Saddle
Insulation
Anvil
Color Code
Dot
Color Code
Dot
Insulation
Crimper
Wire Barrel
Anvil
Die Holding
Screw
Stationary Die
Figure 1
1. INTRODUCTION
The crimping dies listed on this instruction sheet are recommended for crimping the PIDG and PLASTI-GRIP
tape-mounted terminals and splices indicated in Figure 2. The PIDG terminals and splices are used on
stranded copper wire, and the PLASTI-GRIP terminals and splices are used with solid or stranded copper wire.
The dies are designed to be used in AMP-TAPETRONIC* Machine 69875. Refer to Customer Manual
409-1993, packaged with the machine, for information concerning die installation, crimp adjustments, crimping
procedures, and general operation of the machine.
This instruction sheet covers die selection, crimping instructions, and die maintenance and inspection
procedures. Read these instructions thoroughly before crimping any terminals or splices.
NOTE
Measurements are in millimeters [followed by inch equivalents in brackets]. Figures and illustrations are for identification only
and are not drawn to scale.
Reasons for reissue are provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION (Figure 1)
Each die assembly features two stationary dies (anvils) and two moving dies (crimpers), a saddle, and
attaching hardware. One pair of dies (one anvil and one crimper) forms a crimping chamber for the terminal or
splice wire barrel, and the other pair of dies crimps the insulation barrel.
Each half of the die assembly is secured in the machine by a captive screw. The dies are color coded
according to wire size for easy identification. When the terminal or splice is properly crimped in the correct dies,
one or two dots (depending on wire size) will appear on the top and bottom of the terminal or splice.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
© 2014 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
1 of 7
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
5秒后页面跳转
全球首块英伟达H200交付 黄仁勋“送货上门”
常用8脚开关电源芯片型号大全
74HC04芯片引脚图及功能、应用电路图讲解
CR6842芯片参数、引脚配置、应用电路图详解
微信公众号
抖音公众号
浙公网安备 33010502006866号 浙ICP备10014259号-119
营业执照ICP证
数据手册
如果您发现信息不准确，
