DIN Fine-fit Connectors with W-shaped Pins
XC5
International DIN standards; Solderless
Connection Series (Fine Fit)
■ Backplane systems can be designed with ease with
XC5 Connectors as conforming with DIN standards.
■ Using unique W-shaped pins, these Connectors pre-
vent contacts from being bent or falling out.
Ensures highly reliable connections.
■ Less damage to the through-holes in circuit boards.
■ The XC6-series Connectors can be used as Backplane
Connectors.
■ Uses highly-reliable Twin-contact Sockets.
■ A special Press-fit Tool is available.
RoHS Compliant
■Ratings and Characteristics
■Applicable Wrap Post Wire Sizes
AWG30, AWG28, AWG26, or AWG24
(Solid wire: 0.25 to 0.51 mm dia.)
Rated current
2 A
Rated voltage
300 VAC
■Wrap Post Length
3 wires for the 13-mm contacts
4 wires for the 17-mm contacts
Contact resistance
Insulation resistance
20 mΩ max. (at 20 mV, 100 mA max.)
6
10 MΩ min. (at 100 VDC)
Dielectric strength
1,000 VAC for 1 min (leakage current:
1 mA max.)
■Ratings for Fine-fit Connectors
Total insertion force 0.59 N max. per contact
Rated current
2 A
Removal force
0.15 N max. (with test gauge, t = 0.56 mm)
Contact resistance
Pressure input
Holding force
5 mΩ max. (at 20 mV, 100 mA max.)
196 N max. per contact
44.1 N min.
Insertion durability
200 times
Ambient operating
temperature
Operating: −55 to 125°C (with no icing)
Unit torque durability 0.022 N-m min.
Vibration
At 10 to 2,000 Hz, 1.52-mm amplitude, or
■Materials and Finish
15 G will not interrupt current for more
than 1 µ sec.
Type
Plugs
Sockets
Shock
At 100 G, will not break current for more
than 1 µ sec.
Housings
Fiber-glass reinforced PBT resin
(UL94V-0)/gray
Contacts
(See note.) end
Mating
Copper alloy/nickel base, 0.4-µm gold
■Applicable Fine-fit Boards
plating
• Width 1.6 to 3.2 mm
Fine fit
Copper alloy/nickel base, gold flash
plating
• Through-hole diameter 1.0 ±0.08 mm (Drill diameter 1.15
±0.05 mm)
Plating: Copper 25 µm min., or solder 5 µm min. on a copper
base at least 25 µm thick.
Terminal Copper alloy/nickel base, 0.15-µm gold
plating (See note.)
Note: For non-standard plating specifications, contact your
• Pitch error: ±0.03 mm max.
OMRON representative.
1