THE CONNOR-WINFIELD CORP.
2111 COMPREHENSIVE DRIVE.
AURORA, IL 60505.
FAX (630) 851-5040.
PHONE (630) 851-4722.
www.conwin.com
P R O D UC T D ATA S H E E T
CRYSTAL CONTROLLED OSCILLATORS
X533M2
333M
3.3V SURFACE MOUNT 5.0 x 7.5m m
LVDS CLOCK OSCILLATOR
X533
ABSOLUTE MAXIMUM RATINGS
PARAMETER
TABLE 1.0
NOTE
UNITS
MINIMUM NOMINAL MAXIMUM
UNITS
°C
Storage Temperature
-40
-
-
100
7.0
DESCRIPTION
Supply Voltage
(Vcc)
-0.5
Vdc
The Connor-Winfield X533 is a
3.3V Crystal Controlled Oscillator
(XO) with LVDS Differential
outputs. The X533 is designed for
use with PLL systems requiring
tight frequency stability vs.
temperature. The use of
OPERATING SPECIFICATIONS
PARAMETER
TABLE 2.0
NOTE
MINIMUM NOMINAL MAXIMUM
UNITS
MHz
Center Frequency
(Fo)
100
-
-
400
Total Frequency Tolerance
Operating Temperature Range
Supply Voltage
-100
100
ppm
1
0
-
85
°C
(Vcc)
(Icc)
3.135
3.3
-
3.465
Vdc
Supply Current
-
-
-
-
-
-
-
-
60
10
3
-
mA
Jitter (BW=10Hz to 20MHz)
Jitter (BW=12kHz to 80MHz)
SSB Phase Noise at 10Hz offset
SSB Phase Noise at 100Hz offset
SSB Phase Noise at 1KHz offset
SSB Phase Noise at 10KHz offset
SSB Phase Noise at 100KHz offset
-
ps rms
ps rms
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
multiplication is utilized in this
oscillator design.
-
-75
-95
-110
-125
-120
-
-
-
-
INPUT CHARACTERISTICS
PARAMETER
TABLE 3.0
MINIMUM NOMINAL MAXIMUM
UNITS
Vdc
NOTE
FEATURES
-
-
Enable Input Voltage (Low)
Disable Input Voltage (High)
(Vil)
-
0.3Vcc
-
2
2
(Vih)
0.7Vcc
Vdc
3.3V OPERATION
LVDS OUTPUT CHARACTERISTICS
PARAMETER
TABLE 4.0
NOTE
3
LOW JITTER <3pS RMS
MINIMUM NOMINAL MAXIMUM
UNITS
Ohms
mV
LOAD
-
250
45
-
-
-
100
450
55
TOTALFREQUENCY TOLERANCE:
±100ppm
Output Differential Voltage
Duty Cycle at 50% Level
Rise / Fall Time
(Vod)
50
0.6
%
1.0
nS
TEMPERATURE RANGE: 0 to 85°C
DIFFERENTIAL LVDS OUTPUTS
SURFACE MOUNT PACKAGE
TAPEAND REEL PACKAGING
RoHS COMPLIANT / LEAD FREE
PACKAGE CHARACTERISTICS
TABLE 5.0
Package
Hermetically sealed ceramic package with grounded metal cover.
PROCESS RECOMMENDATIONS
Solder Reflow
TABLE 6.0
SMD product suitable for Convection Reflow soldering. Peak temperature
260°C. Maximum time above 220°C, 60 seconds.
Notes
1.0
Inclusive of calibration @ 25°C, frequency stability vs. temperature, control voltage (Vc) = 1.65 Vdc and aging for ten
years.
2.0
3.0
When oscillator is disabled both output are in a high impedance state (Tri-State)
Vod measured with 100 ohm resistor between the true output and the complementary output.
ORDERING INFORMATION
X533
- 333.00MHz
LVDS
CLOCK
SERIES
CENTER
FREQUENCY
Specifications subject to change without notice.
11/07/05
DS019
1
2
02
REV:
Copyright 2001 Connor-Winfield all rights reserved.
DATASHEET #:
PAGE
OF
DATE:
a