X40010, X40011, X40014, X40015
®
Data Sheet
March 28, 2005
FN8111.0
APPLICATIONS
Dual Voltage Monitor with Integrated CPU
Supervisor
• Communication Equipment
—Routers, Hubs, Switches
—Disk Arrays, Network Storage
• Industrial Systems
—Process Control
—Intelligent Instrumentation
• Computer Systems
FEATURES
• Dual voltage detection and reset assertion
—Standard reset threshold settings
See Selection table on page 2.
—Adjust low voltage reset threshold voltages
using special programming sequence
—Computers
—Network Servers
—Reset signal valid to V = 1V
CC
—Monitor three voltages or detect power fail
• Independent Core Voltage Monitor (V2MON)
• Fault detection register
• Selectable power on reset timeout (0.05s,
0.2s, 0.4s, 0.8s)
• Selectable watchdog timer interval (25ms,
200ms,1.4s, off)
• Low power CMOS
DESCRIPTION
The X40010/11/14/15 combines power-on reset con-
trol, watchdog timer, supply voltage supervision, and
secondary voltage supervision, in one package. This
combination lowers system cost, reduces board space
requirements, and increases reliability.
Applying voltage to V
activates the power on reset
—25µA typical standby current, watchdog on
—6µA typical standby current, watchdog off
• 400kHz 2-wire interface
• 2.7V to 5.5V power supply operation
• Available packages
CC
circuit which holds RESET/RESET active for a period of
time. This allows the power supply and system oscilla-
tor to stabilize before the processor can execute code.
—8-lead SOIC, TSSOP
• Monitor Voltages: 5V to 0.9V
• Independent Core Voltage Monitor
BLOCK DIAGRAM
Watchdog Timer
and
Reset Logic
Fault Detection
Data
Register
WDO
Register
SDA
SCL
Status
Register
Command
Decode Test
& Control
Logic
RESET
Threshold
Reset Logic
X40010/14
Power on,
Low Voltage
Reset
RESET
X40011/15
VCC
(V1MON)
+
Generation
User Programmable
VTRIP1
-
V2MON
VCC
+
-
V2FAIL
V2MON
User Programmable
VTRIP2
*X40010/11 = V2MON*
X40014/15 = VCC
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-352-6832 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2005. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.