X3102
®
Data Sheet
December 22, 2004
FN8246.0
3 Cell Li-Ion Battery Protection and
Monitor IC
Features
• Software Selectable Protection Levels and Variable
Protect Detection/Release Times
The X3102 is a protection and monitor IC for use in battery
packs consisting of 3 series Lithium-Ion battery cells. The
device provides internal over-charge, over-discharge, and
overcurrent protection circuitry, internal EEPROM memory,
an internal voltage regulator, and internal drive circuitry for
external FET devices that control cell charge, discharge, and
cell voltage balancing.
• Integrated FET Drive Circuitry
• Cell Voltage and Current Monitoring
• 0.5% Accurate Voltage Regulator
• Integrated 4kbit EEPROM
• Flexible Power Management with 1µA Sleep Mode
• Cell Balancing Control
Over-charge, over-discharge, and overcurrent thresholds
reside in an internal EEPROM memory register and are
selected independently via software using a 3MHz SPI serial
interface. Detection and time-out delays can also be
individually varied using external capacitors.
Benefit
• Optimize protection for chosen cells to allow
maximum use of pack capacity.
Using an internal analog multiplexer, the X3102 allows
battery parameters such as cell voltage and current (using a
sense resistor) to be monitored externally by a separate
microcontroller with A/D converter. Software on this
microcontroller implements gas gauge and cell balancing
functionality in software.
• Reduce component count and cost
• Simplify implementation of gas gauge
• Accurate voltage and current measurements
• Record battery history to optimize gas gauge, track pack
failures and monitor system use
The X3102 contains a current sense amplifier. Selectable
gains of 10, 25, 80 and 160 allow an external 10 bit A/D
converter to achieve better resolution than a more expensive
14 bit converter.
• Reduce power to extend battery life
• Increase battery capacity and improve cycle life battery life
Ordering Information
An internal 4kbit EEPROM memory featuring IDLock™,
allows the designer to partition and “lock in” written battery
cell/pack data.
PART
TEMP. RANGE
(°C)
NUMBER
V
LIMITS
PACKAGE
CC
6V to 24V
X3102V28
-20 to +70
28 Ld TSSOP
The X3102 is housed in a 28 Pin TSSOP package.
Pinout
X3102 (TSSOP)
TOP VIEW
VCELL1
CB1
1
28
VCC
RGP
RGC
RGO
UVP/OCP
OVP/LMON
CS
2
3
4
27
26
25
VCELL2
CB2
VCELL3
CB3
5
24
23
22
21
20
19
6
VSS
7
NC
SCK
SO
8
VSS
9
VCS1
VCS2
OVT
SI
10
AS2
11
18
17
16
15
AS1
12
13
14
UVT
AS0
OCT
AO
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-352-6832 | Intersil (and design) is a registered trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2004. All Rights Reserved
1
All other trademarks mentioned are the property of their respective owners.