WM8940
Mono CODEC with Speaker Driver
DESCRIPTION
FEATURES
•
•
•
•
•
Mono CODEC:
The WM8940 is a low power, high quality mono CODEC
designed for portable applications such as digital still cameras
or camcorders.
Audio sample rates:8, 11.025, 16, 22.05, 24, 32, 44.1, 48kHz
DAC SNR 98dB, THD -84dB (‘A’-weighted @ 8 – 48ks/s)
ADC SNR 94dB, THD -80dB (‘A’-weighted @ 8 – 48ks/s)
On-chip Headphone/Speaker Driver
The device integrates support for a differential or single ended
mic, and includes drivers for speakers or headphone, and
mono line output. External component requirements are
reduced as no separate microphone or headphone amplifiers
are required.
-
-
40mW output power into 16
BTL speaker drive 0.4W into 8
•
•
Additional MONO Line output
Multiple analogue or ‘Aux’ inputs, plus analogue bypass path
Advanced Sigma Delta Converters are used along with digital
decimation and interpolation filters to give high quality audio at
sample rates from 8 to 48ks/s. A selectable high pass filter and
four fully-programmable notch filters are available in the ADC
path. An advanced mixed signal ALC function with noise gate
is provided, while readback of PGA gain during ALC operation
is supported. The digital audio interface supports A-law and -
law companding.
•
•
Mic Preamps:
Differential or single end Microphone Interface
-
-
-
Programmable preamp gain
Pseudo differential inputs with common mode rejection
Programmable ALC / Noise Gate in ADC path
•
Low-noise bias supplied for electret microphones
OTHER FEATURES
•
•
•
•
•
Digital Playback Limiter
An on-chip PLL is provided to generate the required Master
Clock from an external reference clock. The PLL clock can
also be output if required elsewhere in the system.
Programmable high pass filter (wind noise reduction)
4 notch filters (narrowband noise suppression)
On-chip PLL
Low power, low voltage
The WM8940 operates at supply voltages from 2.5 to 3.6V,
although the digital supplies can operate at voltages down to
1.71V to save power. Different sections of the chip can also be
powered down under software control using the selectable two
or three wire control interface.
-
2.5V to 3.6V (digital: 1.71V to 3.6V)
•
4x4x0.9mm 24 lead QFN package
APPLICATIONS
•
•
Digital still cameras and camcorders
General purpose mono audio CODEC
WM8940 is supplied in a very small 4x4mm QFN package,
offering high levels of functionality in minimum board area, with
high thermal performance.
Rev 4.4
JAN 2022
Copyright © Cirrus Logic, Inc., 2006–2022
http://www.cirrus.com
(All Rights Reserved)