VInte6llig0ent0Fl-agHI/IIA
Innovative RFID Electronic Flags to
Replace Mechanical Flag and Kanban
Systems
• Doesn't need a program and can be used like a sensor.
• Advanced line construction at minimal cost.
• Saves space.
• Precise installation not required (Transmission distance:
100 mm max.).
• A verification function provided on multi-functional type.
• Addition of 16-bit models to the series responds to applica-
tions from Kanban to quality control.
• Equipped with a wiring reduction mode and communications
parity check function (16-bit models).
• Both NPN and PNP output available.
• FCC certified.
Ordering Information/Specifications
■ Amplifier
Type
Read-only (8-bit)
V600-HAR91 V600-HAR81
24 VDC 10%, ripple (p-p): 10%
Multi-functional (8-bit)
V600-HAM91 V600-HAM81
Read-only (16-bit)
V600-HAR92
Item
Model
Power supply
Current consumption 130 mA max.
Transistor output
Input
Transistor output or contact output
Short-circuit current: 3 mA (typical) (IN terminal and 0-V short-circuit)
OFF voltage:
15 to 30 VDC
Input impedance:
8.2 kΩ
OFF voltage:
ON voltage:
Input impedance:
Applied voltage:
15 to 30 VDC
0 to 5 VDC
8.2 kΩ
Short-circuit current:
3 mA (typical) (for 0-V short-circuit of
INHIBIT/TRG)
30 VDC max.
ON voltage:
0 to 5 VDC
Applied voltage:
30 VDC max.
NPN open collector
PNP open collector NPN open collector
PNP open collector out- NPN open collector output, 20 mA
Output
output, 20 mA max. at output, 20 mA max. output, 20 mA max. at put, 20 mA max. at 30
max. at 30 VDC, residual voltage: 2 V
30 VDC, residual volt- at 30 VDC, residual 30 VDC, residual volt- VDC, residual voltage: 2 V max.
age: 2 V max. voltage: 2 V max. age: 2 V max. max.
Diagnostic functions Checks for CPU errors and transmission errors
Insulation resistance 50 MΩ max. (at 500 VDC) between cable terminals and case
Dielectric strength
500 VAC, 50/60 Hz for 1 min between cable terminals and case (leakage current: 1 mA max.)
2
Intelligent Flag I/II V600-HA