ALUMINUM ELECTROLYTIC CAPACITORS
Miniature Sized, Low Impedance,
High Reliability For Switching Power Supplies
TT series
Approved by Reliability Center for Electronic
Component, Japan-Certification No. RCJ-03-23C
Smaller case size and Long Life product.
Compliant to the RoHS directive (2011/65/EU).
Long Life
P W
T T
Specifications
ltem
Performance Characteristics
Temperature Range –40 to +105˚C
Category
Rated Voltage Range
6.3 to 50V
F
Rated Capacitance Range 1 to 470µ
Capacitance Tolerance
Leakage Current
± 20% at 120Hz, 20˚C
After 2 minutes' application of rated voltage, leakage current is less than 0.03CV or 3 ( A), whichever is greater.
µ
Measurement frequency : 120Hz at 20°C
Rated voltage (V)
6.3
10
16
25
35
50
Tangent of loss angle (tan δ)
tan δ (MAX.)
0.30
0.28
0.24
0.18
0.16
0.14
Measurement frequency : 120Hz
Rated voltage (V)
Z–25°C / Z+20°C
Z–40°C / Z+20°C
6.3
5
10
10
4
10
16
3
8
25
3
6
35
3
4
50
3
4
Stability at Low Temperature
Impedance ratio
ZT / Z20 (MAX.
)
The specifications listed at right shall be met when the
Capacitance change Within ±30% of the initial capacitance value
˚C
capacitors are restored to 20 after the rated voltage is
˚C.
tan δ
300% or less than the initial specified value
Less than or equal to the initial specified value
Endurance
applied for 5000 hours at 105
Leakage current
After storing the capacitors under no load at 105˚C for 1000 hours and then performing voltage treatment based on JIS C 5101-4
clause 4.1 at 20°C, they shall meet the specified values for the endurance characteristics listed above.
Shelf Life
Marking
Printed with white color letter on dark blown sleeve.
Type numbering system (Example : 25V 100µF)
Radial Lead Type
φd
Sleeve (P.E.T.)
1
2
3
4
5
6
7
8
9
10 11
U T T 1 E 1 0 1 M
P D
Configuration
Capacitance tolerance (± 20%)
Rated capacitance (100µF)
Rated voltage (25V)
Series name
MIN
MIN
4
+
MAX.
15
L
Pressure relief vent
Type
(φ8up)
Configuration
Pb-free leadwire
φ D
Pb-free PET sleeve
(mm)
8
4 to 6.3
8
DD
PD
(L = 7) 1.0
(L 9) 1.5
φD
4
5
6.3
2.5
P
1.5
2.0
3.5
0.6
0.5
φd
0.45 0.45
(0.45)
(
) : Applied to 7mmL products
• Please refer to page 20 about the end seal configuration.
Please refer to page 20, 21, 22 about the formed or taped product spec.
Please refer to page 4 for the minimum order quantity.
Dimension table in next page.
CAT.8100C