5秒后页面跳转
UCC3917 PDF预览

UCC3917

更新时间: 2024-11-19 22:52:39
品牌 Logo 应用领域
德州仪器 - TI /
页数 文件大小 规格书
9页 230K
描述
Positive Floating Hot Swap Power Manager

UCC3917 数据手册

 浏览型号UCC3917的Datasheet PDF文件第2页浏览型号UCC3917的Datasheet PDF文件第3页浏览型号UCC3917的Datasheet PDF文件第4页浏览型号UCC3917的Datasheet PDF文件第5页浏览型号UCC3917的Datasheet PDF文件第6页浏览型号UCC3917的Datasheet PDF文件第7页 
application  
INFO  
UCC1917  
UCC2917  
UCC3917  
available  
Positive Floating Hot Swap Power Manager  
FEATURES  
DESCRIPTION  
Manages Hot Swap of 15V and  
The UCC3917 family of positive floating hot swap managers provides complete  
power management, hot swap, and fault handling capability. The voltage limita-  
tion of the application is only restricted by the external component voltage limi-  
tations. The IC provides its own supply voltage via a charge pump off of VOUT.  
The onboard 10V shunt regulator protects the IC from excess voltage. The IC  
also has catastrophic fault indication to alert the user that the ability to shut off  
the output NMOS has been bypassed. All control and housekeeping functions  
are integrated and externally programmable. These include the fault current  
level, maximum output sourcing current, maximum fault time, soft start time,  
and average NMOS power limiting.  
Above  
Precision Fault Threshold  
Programmable Average Power  
Limiting  
Programmable Linear Current  
Control  
Programmable Overcurrent Limit  
Programmable Fault Time  
The fault level across the current sense amplifier is fixed at 50mV to minimize  
total drop out. Once 50mV is exceeded across the current sense resistor, the  
fault timer will start. The maximum allowable sourcing current is programmed  
with a voltage divider from the VREF/CATFLT pin to generate a fixed voltage  
on the MAXI pin. The current level at which the output appears as a current  
source is equal to VMAXI divided by the current sense resistor. If desired, a con-  
trolled current startup can be programmed with a capacitor on MAXI.  
Internal Charge Pump to Control  
External NMOS Device  
Fault Output and Catastrophic  
Fault Indication  
Fault Mode Programmable to  
Latch or Retry  
When the output current is below the fault level, the output device is switched  
on with full gate drive. When the output current exceeds the fault level, but is  
less than maximum allowable sourcing level programmed by MAXI, the output  
remains switched on, and the fault timer starts charging CT. Once CT charges  
to 2.5V, the output device is turned off and attempts either a retry sometime  
later or waits for the state on the LATCH pin to change if in latch mode. When  
the output current reaches the maximum sourcing current level, the output de-  
vice appears as a current source.  
Shutdown Control  
Undervoltage Lockout  
BLOCK DIAGRAM  
VDD  
13  
LATCH  
16  
V
1
3
PLIM  
DD  
UVLO  
>10V=ENABLE  
< 6V=DISABLE  
V
DD  
5V  
40µA  
VDD  
40µA  
DISABLE  
SHTDWN 12  
VOUT  
OUTPUT  
VOUT  
OUTPUT  
LOW  
VOUT  
FLTOUT 11  
5V  
C1P  
8
OVER  
CURRENT  
REFERENCE  
50mV  
COMPARATOR  
LOGIC  
SUPPLY  
2
4
SENSE  
VOUT  
ON-TIME  
DELAY  
C1N  
C2P  
C2N  
7
6
5
10 CT  
4V  
200mV  
9
15  
VREF/CATFLT  
14  
MAXI  
UDG-99055  
VSS  
SLUS203A - AUGUST 1999  

与UCC3917相关器件

型号 品牌 获取价格 描述 数据表
UCC3917D TI

获取价格

Positive Floating Single, Hot-Swap IC Commercial Temp. 16-SOIC 0 to 70
UCC3917DG4 TI

获取价格

1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16, GREEN, PLASTIC, MS-012AC, SOIC-16
UCC3917DTR TI

获取价格

Positive Floating Single, Hot-Swap IC Commercial Temp. 16-SOIC 0 to 70
UCC3917DTRG4 TI

获取价格

1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16, GREEN, PLASTIC, MS-012AC, SOIC-16
UCC3917J TI

获取价格

Positive Floating Hot-Swap Power Manager
UCC3917N TI

获取价格

Positive Floating Single, Hot-Swap IC Commercial Temp. 16-PDIP 0 to 70
UCC3918 TI

获取价格

Low On Resistance Hot Swap Power Manager
UCC3918DP TI

获取价格

LOW ON-RESISTANCE HOT SWAP POWER MANAGER
UCC3918DP ROCHESTER

获取价格

1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO16, GREEN, SOIC-16
UCC3918DPTR TI

获取价格

LOW ON-RESISTANCE HOT SWAP POWER MANAGER