Support &
Community
Product
Folder
Order
Now
Tools &
Software
Technical
Documents
UCC27282-Q1
SLUSDN5A –SEPTEMBER 2019–REVISED JUNE 2020
UCC27282-Q1 Automotive 120-V Half-Bridge Driver
with Cross Conduction Protection and Low Switching Losses
1 Features
3 Description
The UCC27282-Q1 is a robust N-channel MOSFET
1
•
AEC-Q100 qualified with following results
driver with a maximum switch node (HS) voltage
rating of 100 V. It allows for two N-channel MOSFETs
to be controlled in half-bridge or synchronous buck
configuration based topologies. Its 3.5-A peak sink
current and 2.5-A peak source current along with low
pull-up and pull-down resistance allows the
UCC27282-Q1 to drive large power MOSFETs with
minimum switching losses during the transition of the
MOSFET Miller plateau. Since the inputs are
independent of the supply voltage, UCC27282-Q1
can be used in conjunction with both analog and
digital controllers.
–
–
–
Temperature grade 1 (Tj = –40°C to 150°C)
HBM ESD classification level 1B
CDM ESD classification level C3
•
Drives two N-channel MOSFETs in high-side low-
side configuration
•
•
•
•
•
•
•
5-V typical under voltage lockout
Input interlock
Enable/disable functionality in DRC package
16-ns typical propagation delay
12-ns rise, 10-ns fall time with 1.8-nF load
1-ns typical delay matching
The input pins as well as the HS pin are able to
tolerate significant negative voltage, which improves
system robustness. Input interlock further improves
robustness and system reliability in high noise
applications. The enable and disable functionality
provides additional system flexibility by reducing
power consumption by the driver and responds to
fault events within the system. 5-V UVLO allows
systems to operate at lower bias voltages, which is
necessary in many high frequency applications and
improves system efficiency in certain operating
modes. Small propagation delay and delay matching
specifications minimize the dead-time requirement
which further improves efficiency.
Absolute Maximum Negative Voltage Handling on
Inputs (–5 V)
•
Absolute Maximum Negative Voltage Handling on
HS (–14 V)
•
•
•
•
3.5-A sink, 2.5-A Source output currents
Absolute maximum boot voltage 120 V
Low current (7-µA) consumption when disabled
Integrated bootstrap diode
2 Applications
•
•
•
•
•
Automotive DC/DC converters
Electric power steering
Under voltage lockout (UVLO) is provided for both the
high-side and low-side driver stages forcing the
outputs low if the VDD voltage is below the specified
threshold. An integrated bootstrap diode eliminates
the need for an external discrete diode in many
applications, which saves board space and reduces
system cost. UCC27282-Q1 is offered in a small
package enabling high density designs.
On-board charger (OBC)
Integrated belt starter generator (iBSG)
Automotive HVAC compressor modules
Simplified Application Diagram
Device Information(1)
7V
75V
PART NUMBER
PACKAGE (DESIGNATOR) (SIZE)
SON10 (DRC) (3 mm x 3 mm)
SOIC8 (D) (6 mm x 5mm))
UCC27282-Q1
VDD
EN
HO
NC
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
HI
HB
To Load
LI
HS
0 …F
VSS
LO
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.