5秒后页面跳转
UC2726DWPTR PDF预览

UC2726DWPTR

更新时间: 2024-01-11 03:14:00
品牌 Logo 应用领域
德州仪器 - TI 驱动
页数 文件大小 规格书
6页 335K
描述
Isolated Drive Transmitter 28-SOIC -40 to 85

UC2726DWPTR 技术参数

是否无铅:含铅是否Rohs认证:不符合
生命周期:Obsolete零件包装代码:SOIC
包装说明:SOIC-28针数:28
Reach Compliance Code:not_compliantECCN代码:EAR99
HTS代码:8542.39.00.01风险等级:5.84
Is Samacsys:N内置保护:UNDER VOLTAGE
接口集成电路类型:HALF BRIDGE BASED PERIPHERAL DRIVERJESD-30 代码:R-PDSO-G28
长度:17.9 mm功能数量:1
端子数量:28最高工作温度:85 °C
最低工作温度:-40 °C输出电流流向:SOURCE AND SINK
标称输出峰值电流:1.5 A封装主体材料:PLASTIC/EPOXY
封装代码:SOP封装等效代码:SOP28,.4
封装形状:RECTANGULAR封装形式:SMALL OUTLINE
峰值回流温度(摄氏度):NOT SPECIFIED电源:20 V
认证状态:Not Qualified座面最大高度:2.65 mm
子类别:Peripheral Drivers最大供电电压:35 V
最小供电电压:8 V标称供电电压:20 V
表面贴装:YES技术:BIPOLAR
温度等级:INDUSTRIAL端子形式:GULL WING
端子节距:1.27 mm端子位置:DUAL
处于峰值回流温度下的最长时间:NOT SPECIFIED宽度:7.5 mm
Base Number Matches:1

UC2726DWPTR 数据手册

 浏览型号UC2726DWPTR的Datasheet PDF文件第2页浏览型号UC2726DWPTR的Datasheet PDF文件第3页浏览型号UC2726DWPTR的Datasheet PDF文件第4页浏览型号UC2726DWPTR的Datasheet PDF文件第5页浏览型号UC2726DWPTR的Datasheet PDF文件第6页 
UC1726  
UC2726  
UC3726  
Isolated Drive Transmitter  
DESCRIPTION  
FEATURES  
750mA Output Drive, Source or Sink  
The UC1726 Isolated Drive Transmitter, and its companion chip, the  
UC1727 Isolated High Side IGBT Driver, provide a unique solution to driv-  
ing isolated power IGBTs. They are particularly suited to drive the high  
side devices on a high voltage H-bridge. The UC1726 device transmits  
the drive logic and drive power, along with transferring and receiving fault  
information with the isolated gate circuit using a low cost pulse trans-  
former.  
8 to 35V Operation  
Transmits Drive Logic and Power  
through Low Cost Transformer  
Programmable Operating Frequency  
Up to 750kHz Operation  
This drive system utilizes a duty cycle modulation technique that gives in-  
stantaneous response to the drive control transitions, and reliably passes  
steady state, or DC conditions. High frequency operation, up to 750kHz,  
allows the cost and size of the coupling transformer to be minimized.  
Improved Output Control Algorithm  
Minimizes Output Jitter  
Fault Logic Monitors Isolated High  
Side IGBT Driver UC1727 for Faults  
The UC1726 can be powered from a single VCC supply which internally  
generates a voltage reference for the logic circuitry. It can also be placed  
into a low power shutdown mode that disables the internal reference. The  
IC’s logic circuitry can be powered from an external supply, VL, to mini-  
mize overall power dissipation. Fault logic monitors the Isolated High Side  
IGBT Driver UC1727 for faults. Based on user defined timing, the  
UC1726 distinguishes valid faults, which it responds to by setting the fault  
latch pin. This also disables the gate drive information until the fault reset  
pin is toggled to a logic one.  
User Programmable Fault Timing  
Screens False Fault Signals  
Shutdown Mode Disables On Chip  
Logic Reference for Low Standby  
Power  
Optional External Biasing of Logic  
Circuitry can Reduce Overall Power  
Dissipation  
The UC1726 operates over an 8 to 35 volt supply range. The typical VCC  
voltage will be greater than 28 volts to be compatible with the UC1727.  
The undervoltage lockout circuitry of the Isolated High Side IGBT Driver  
UC1727 locks out the drive information during its undervoltage lockout.  
BLOCK DIAGRAM  
UDG-94004-1  
7/95  

与UC2726DWPTR相关器件

型号 品牌 获取价格 描述 数据表
UC2726J TI

获取价格

0.75A HALF BRIDGE BASED PRPHL DRVR, CDIP18, DIP-18
UC2726N TI

获取价格

Isolated Drive Transmitter 16-PDIP -40 to 85
UC2726QP ETC

获取价格

Transistor Driver
UC2726QPTR ETC

获取价格

Transistor Driver
UC2726SP TI

获取价格

暂无描述
UC2727 TI

获取价格

Isolated High Side IGBT Driver
UC2727DWP TI

获取价格

Isolated High Side IGBT Driver
UC2727DWPTR TI

获取价格

Isolated High Side IGBT Driver
UC2727J TI

获取价格

Isolated High Side IGBT Driver
UC2727LP ETC

获取价格

Single Peripheral Driver