5秒后页面跳转
UC27132 PDF预览

UC27132

更新时间: 2024-11-20 22:41:51
品牌 Logo 应用领域
德州仪器 - TI 开关
页数 文件大小 规格书
10页 92K
描述
Smart Power Switch

UC27132 数据手册

 浏览型号UC27132的Datasheet PDF文件第2页浏览型号UC27132的Datasheet PDF文件第3页浏览型号UC27132的Datasheet PDF文件第4页浏览型号UC27132的Datasheet PDF文件第5页浏览型号UC27132的Datasheet PDF文件第6页浏览型号UC27132的Datasheet PDF文件第7页 
UC17131/2/3  
UC27131/2/3  
UC37131/2/3  
Smart Power Switch  
FEATURES  
DESCRIPTION  
300mA Continuous Output Current  
The UC37131, UC37132 and UC37133 are a family of smart power  
switches which can drive resistive or inductive loads from the high side or  
low side.  
Low Side or High Side Switch  
Configuration  
The UC37132 is available in 14 pin (DIP), 16 pin (SOIC), or 20 pin (CLCC)  
packages and can accommodate both low side (load to VCC) or high side  
(load to GND) configurations. The UC37131 and UC37133 are exclusively  
for a low side or a high side configuration respectively and both are avail-  
able in an 8 pin package. Both high side and low side configurations provide  
high current switching with low saturation voltages which can drive resistive  
or inductive loads.  
8V to 65V Operation  
Overload and Short Circuit Protection  
Power Interruption Protection  
+6V Regulated Voltage  
2mA Quiescent Current  
The input to the switch is driven by a low voltage signal, typically 5V. Addi-  
tionally, UC37132 features adjustable hysteresis. The output of the device  
can switch a load between 8V and 65V. Output current capability is 300mA  
continuous or 700mA peak.  
Programmable Overcurrent and  
Power Interruption Protection  
1% to 30% Programmable Input  
Comparator Hysteresis (on UC37132)  
The device also has inherent smart features that allow for programmable  
turn-on delay in enabling the output following startup. The same capacitor  
that specifies the turn-on delay is also used to program a VCC power inter-  
ruption time. If VCC drops below a threshold for a time specified by this ca-  
pacitor, the output is turned off and a new turn-on delay will be re-triggered.  
Similarly, if high current persists longer than the response delay, the output  
driver will operate in a very low duty cycle mode to protect the IC.  
Low and High Side Internal High  
Current Clamps When Driving  
Inductive Loads  
UC37132 BLOCK DIAGRAM  
6V  
VREF 11  
6V/8mA  
7
6
5
VCC  
CSH  
LS  
PRE-REGULATOR  
INPUT  
COMPARATOR  
IN 13  
72V  
QOUT  
TURN-ON/OFF  
AND  
SHORT CIRCUIT  
PROTECTION  
4
3
2
HS  
1/2  
VREF  
CSL  
GND  
12  
9
10  
HYST  
LED  
CDEL  
UDG-98026  
SLUS340 - APRIL 1999  

与UC27132相关器件

型号 品牌 获取价格 描述 数据表
UC27132D TI

获取价格

0.9A BUF OR INV BASED PRPHL DRVR, PDSO16, 0.150 INCH, PLASTIC, SOIC-16
UC27132DG4 TI

获取价格

暂无描述
UC27132DTR ETC

获取价格

Single Peripheral Driver
UC27132DTRG4 TI

获取价格

IC,PERIPHERAL DRIVER,1 DRIVER,BIPOLAR,SOP,14PIN,PLASTIC
UC27132J TI

获取价格

0.7A BUF OR INV BASED PRPHL DRVR, CDIP14, DIP-14
UC27132N ETC

获取价格

Single Peripheral Driver
UC27132NG4 TI

获取价格

IC,PERIPHERAL DRIVER,1 DRIVER,BIPOLAR,DIP,14PIN,PLASTIC
UC27133 TI

获取价格

Smart Power Switch
UC27133D TI

获取价格

Smart Power Switch
UC27133DG4 TI

获取价格

Smart Power Switch