5秒后页面跳转
TUSB217ARWBT PDF预览

TUSB217ARWBT

更新时间: 2024-11-16 02:50:39
品牌 Logo 应用领域
德州仪器 - TI /
页数 文件大小 规格书
31页 4325K
描述
TUSB217A USB 2.0 High-Speed Signal Conditioner With DCP and CDP Controllers

TUSB217ARWBT 数据手册

 浏览型号TUSB217ARWBT的Datasheet PDF文件第2页浏览型号TUSB217ARWBT的Datasheet PDF文件第3页浏览型号TUSB217ARWBT的Datasheet PDF文件第4页浏览型号TUSB217ARWBT的Datasheet PDF文件第5页浏览型号TUSB217ARWBT的Datasheet PDF文件第6页浏览型号TUSB217ARWBT的Datasheet PDF文件第7页 
TUSB217A  
SLLSFK5 – JUNE 2021  
TUSB217A USB 2.0 High-Speed Signal Conditioner With DCP and CDP Controllers  
1 Features  
3 Description  
Wide supply voltage range: 2.3 - 6.5 V  
Ultra-low USB disconnect and shutdown power  
consumption  
Provides USB 2.0 high-speed signal conditioning  
Compatible with USB 2.0, OTG 2.0 and BC 1.2  
Support for low-speed, full-speed, high-speed  
signaling  
Integrated BC 1.2 Charging Downstream  
Port (CDP) and Dedicated Charging Port  
(DCP) controllers that dynamically changes per  
DCP/CDP pin  
The TUSB217A is a third-generation USB 2.0 high-  
speed signal conditioner designed to compensate  
both AC loss (due to capacitive load) and DC loss  
(due to resistive loss) in the transmission channel.  
The TUSB217A leverages a patented design to  
speed-up transition edges of USB 2.0 high-speed  
signal with an edge booster and increases static  
levels with a DC boost function. In addition, the  
TUSB217A includes a pre-equalization function to  
improve the receiver sensitivity and compensate the  
inter-symbol interference (ISI) jitter in application  
with longer cable length. USB low-speed and full-  
speed signal characteristics are unaffected by the  
TUSB217A.  
Host/Device agnostic  
Supports up to 5-m cable length  
– Four selectable signal boost (edge boost along  
with DC boost) settings via external pull-down  
resistor values  
– Three selectable RX equalization settings via  
pull-up-or-down to compensate ISI jitter for  
high-loss applications  
Supports up to 10-m cable length with two  
TUSB217A devices  
Scalable solution - devices can be daisy chained  
for high loss applications  
The TUSB217A improves signal quality without  
altering packet timing or adding propagation delay or  
latency.  
The TUSB217A helps a system to pass the USB 2.0  
high-speed near end eye compliance with a cable as  
long as 5 meters.  
The TUSB217A is compatible with the USB On-The-  
Go (OTG) and battery charging (BC 1.2) protocols.  
The Integrated BC 1.2 battery charging controller can  
be enabled via a control pin.  
RWB is pin compatible with TUSB211/212/214/216  
2 Applications  
Laptop, desktop/docking stations  
Portable electronics  
Tablets  
Cell phones  
Televisions  
Device Information  
PART  
NUMBER  
OP TEMP (TA)  
°C  
BODY SIZE  
(NOM)  
PACKAGE  
X2QFN  
(12RWB)  
1.60 mm x 1.60  
mm  
TUSB217A  
TUSB217AI  
2.3 œ 6.5V  
0 to 70  
Active cable, cable extenders, backplane  
X2QFN  
(12RWB)  
1.60 mm x 1.60  
mm  
-40 to 85  
VCC  
USB  
Host  
USB  
Cable  
D2  
D1  
Connector  
GND  
Simplified Schematic  
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,  
intellectual property matters and other important disclaimers. PRODUCTION DATA.  
 
 

与TUSB217ARWBT相关器件

型号 品牌 获取价格 描述 数据表
TUSB217ARWBTQ1 TI

获取价格

TUSB217A-Q1 USB 2.0 High-Speed Signal Conditioner With DCP and CDP Controllers
TUSB217-Q1 TI

获取价格

具有直流升压、集成式 CDP 和宽电源的汽车 USB 2.0 高速信号调节器
TUSB217RGYRQ1 TI

获取价格

具有直流升压、集成式 CDP 和宽电源的汽车 USB 2.0 高速信号调节器 | RGY
TUSB217RGYTQ1 TI

获取价格

具有直流升压、集成式 CDP 和宽电源的汽车 USB 2.0 高速信号调节器 | RGY
TUSB2551 TI

获取价格

ADVANCED UNIVERSAL SERIAL BUS TRANSCEIVER
TUSB2551_10 TI

获取价格

ADVANCED UNIVERSAL SERIAL BUS TRANSCEIVER
TUSB2551A TI

获取价格

ADVANCED UNIVERSAL SERIAL BUS TRANSCEIVER
TUSB2551APW TI

获取价格

ADVANCED UNIVERSAL SERIAL BUS TRANSCEIVER
TUSB2551APWR TI

获取价格

ADVANCED UNIVERSAL SERIAL BUS TRANSCEIVER
TUSB2551ARGTR TI

获取价格

ADVANCED UNIVERSAL SERIAL BUS TRANSCEIVER