TUSB217A-Q1
SLLSFK6 – SEPTEMBER 2021
TUSB217A-Q1 USB 2.0 High-Speed Signal Conditioner With DCP and CDP Controllers
1 Features
3 Description
•
AEC-Q100 qualified for automotive applications
– Device temperature grade 2:
The TUSB217A-Q1 is
a
third-generation USB
2.0 high-speed signal conditioner designed to
compensate both AC loss (due to capacitive load) and
DC loss (due to resistive loss) in the transmission
channel.
-40°C to 105°C TA
•
•
Wide supply voltage range: 2.3 – 6.5 V
Ultra-low USB disconnect and shutdown power
consumption
Provides USB 2.0 high-speed signal conditioning
Compatible with USB 2.0, OTG 2.0 and BC 1.2
Support for low-speed, full-speed, high-speed
signaling
Integrated BC 1.2 Charging Downstream
Port (CDP) and Dedicated Charging Port
(DCP) controllers that dynamically changes per
DCP/CDP pin
The TUSB217A-Q1 leverages a patented design to
speed-up transition edges of USB 2.0 high-speed
signal with an edge booster and increases static
levels with a DC boost function. In addition, the
TUSB217A-Q1 includes a pre-equalization function
to improve the receiver sensitivity and compensate
the inter-symbol interference (ISI) jitter in application
with longer cable length. USB low-speed and full-
speed signal characteristics are unaffected by the
TUSB217A-Q1.
•
•
•
•
•
•
Host or device agnostic
Supports up to 5-m cable length
The TUSB217A-Q1 improves signal quality without
altering packet timing or adding propagation delay or
latency.
– Four selectable signal boost (edge boost along
with DC boost) settings through the external
pull-down resistor values
– Three selectable RX equalization settings
through the pull-up-or-down to compensate ISI
jitter for high-loss applications
Supports up to 10-m cable length with two
TUSB217A-Q1 devices
Scalable solution – devices can be daisy chained
for high loss applications
RWB is pin compatible with TUSB211/212/214/216
The TUSB217A-Q1 helps a system to pass the USB
2.0 high-speed near end eye compliance with a cable
as long as 5 meters.
•
•
•
The TUSB217A-Q1 is compatible with the USB
On-The-Go (OTG) and battery charging (BC 1.2)
protocols. The Integrated BC 1.2 battery charging
controller can be enabled through a control pin.
Device Information(1)
2 Applications
PART NUMBER
PACKAGE
BODY SIZE (NOM)
•
•
•
Automotive infotainment and cluster
Automotive head unit
Active cable, cable extenders, backplane
TUSB217A-Q1
X2QFN (12RWB)
1.60 mm × 1.60 mm
(1) For all available packages, see the orderable addendum at
the end of the data sheet.
2.3 œ 6.5V
VCC
USB
USB
Cable
D2
D1
Host
Connector
GND
Simplified Schematic
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.