TSOP332.., TSOP334..
www.vishay.com
Vishay Semiconductors
IR Receiver Modules for Remote Control Systems
FEATURES
• Very low supply current
• Photo detector and preamplifier in one package
• Internal filter for PCM frequency
• Supply voltage: 2.5 V to 5.5 V
• Improved immunity against ambient light
• Insensitive to supply voltage ripple and noise
• Compatible with wave or reflow soldering
(see “P” version of Minimold option datasheets)
• Material categorization:
for definitions of compliance please see
www.vishay.com/doc?99912
DESCRIPTION
The TSOP332.. and TSOP334.. series are miniaturized IR
receiver modules for infrared remote control systems. A PIN
diode and a preamplifier are assembled on lead frame, the
epoxy package contains an IR filter.
MECHNICAL DATA
Pinning for TSOP334..:
The demodulated output signal can be directly connected to
a microprocessor for decoding.
1 = OUT, 2 = GND, 3 = VS
The TSOP334.. series devices are optimized to suppress
almost all spurious pulses from energy saving lamps like
CFLs. The AGC4 used in the TSOP334.. may suppress
some data signals. The TSOP332.. series are provided
primarily for compatibility with old AGC2 designs. New
designs should prefer the TSOP334.. series containing the
newer AGC4.
These components have not been qualified according to
automotive specifications.
PARTS TABLE
AGC
LEGACY, FOR LONG BURSTS (AGC2)
TSOP33230
FOR LONG BURSTS, VERY NOISY ENVIRONMENTS (AGC4)
30 kHz
33 kHz
TSOP33430
TSOP33433
TSOP33233
36 kHz
TSOP33236
TSOP33436 (1)(2)(3)
TSOP33438 (4)(5)
TSOP33440
Carrier
frequency
38 kHz
40 kHz
56 kHz
TSOP33238
TSOP33240
TSOP33256
TSOP33456 (6)(7)
Package
Pinning
Minimold
1 = OUT, 2 = GND, 3 = VS
5.4 W x 6.35 H x 4.9 D
Leaded
Dimensions (mm)
Mounting
Application
Best remote control code
Remote control
(1) RC-5 (2) RC-6 (3) Panasonic (4) NEC (5) Sharp (6) r-step (7) Thomson RCA
BLOCK DIAGRAM
APPLICATION CIRCUIT
17170-11
16833-13
R1
3
Transmitter
with
TSALxxxx
IR receiver
VS
+ VS
30 kΩ
C1
1
μC
Band
pass
Demo-
dulator
OUT
Input
AGC
VO
GND
GND
2
PIN
Control circuit
R1 and C1 recommended to reduce supply ripple for VS < 2.8 V
Rev. 1.3, 22-Jul-16
Document Number: 82663
1
THIS DOCUMENT IS SUBJECT TO CHANGE WITHOUT NOTICE. THE PRODUCTS DESCRIBED HEREIN AND THIS DOCUMENT
ARE SUBJECT TO SPECIFIC DISCLAIMERS, SET FORTH AT www.vishay.com/doc?91000